Routers - Small Business

Here in Brazil VIVO (from the spanish Telefonica group) is recently providing fiber links.Their fiber link is being splitted into 2 vlans: one for their IPTV (vlan id 20) and another for internet (vlan id 10).So, when they install on your house or co...

Hi All, Is anyone here using the RV315W Router ? I'm trying to configure a PC to Site connection but I can't find how to create the VPN user on this router. Does the User Management in System Management menu relate to this ? I have tried this but sti...

Hi, I've been looking over the specs for the 1921 ISR router and saw mentioned that it has something like "15Mbps total throughput". My question is, is that 15Mbps total throughput with several "services" turned on (such as QoS or VPN) or is that wit...

CISCO rv130w port forwarding does not work. not the factory version 1.0.1.3 or 1.0.2.7 with another. I tried only firewall rule only port forwarding, and their combinations as well.I'm desperate, we bought this device, because of the brand and knowle...

I have a RV220W for my home network.  It's always performed perfectly.  I recently purchased a Raspberry Pi media device and when it was plugged into my router, all the network device lights went out and my network was effectively neutralized.  I rem...

Hi! We have to RV325 and trying to make VPN tunnel site to site. I have made configuration according to manual but all i can see is waiting to connect. They will not connect. I have made sure that configuration is exactly the same on both sites. But ...

Hello Guys, Good day! Is it possible to use IP range in source or destination in creating ACL? My ACL implementation always either single IP or the whole subnet. Appreciate any input on this. Thanks! Regards, Chris

I have 2 RV042's that up until the 18th of this month was working fine via a point to point tunnel, now they wont connect and give me the ipt_tcpmss_target: bad length but i havent been able to figure out the issue.. i have deleted the tunnels and ma...

I installed a RV130W behind a Arris SB6141 modem.  ISP is Comcast.  I get 120Mbps when connected directly to the modem.  With only my laptop connected via Ethernet to the router the max speed is 75Mbps.  I flashed the firmware to the latest version. ...

I have an RV042G that was working just fine, and it suddenly stopped providing internet to LAN computers.  I am using Verizon Fios and I have a LAN port on the modem connected to the WAN1 port on the router, and then my network switch connected to a ...

Dear All, I got an old-yet-fully-functional srp526w (ADSL2+ over ISDN), that I would like to use within our infrastructure (ADSL2+ over POTS): is it worth trying to change the srp526w into a srp527w (ADSL+ over POTS) via firmware? Or are there hardw...

Dear All, I got an old-yet-fully-functional srp526w (ADSL2+ over ISDN), that I would like to use within our infrastructure (ADSL2+ over POTS): is it worth trying to change the srp526w into a srp527w (ADSL+ over POTS) via firmware? Or are there hardw...

Hello Cisco Team Hope you can help us We migrate 2013 from RV-082 Now we have an Cisco RV-016 Router with actual Firmware. Additional we get an additional Internet Line (WAN6) Configuration: Wan 1=Internet / Telekom 16Mbit Wan 2=Internet / Telekom 16...

Hi all, Just bought and set up an RV130 that replaces a Ubiquiti Edgrouter. Having a number of issues where a number of devices are dropping from the network now. I have configured the router with static Ip's for some of the devices. Primarily, w...