Routers - Small Business

Hi Seems like a hard issue to track down a definitive guide on - I have two RV042 routers in separate sites - both are stuck behind ADSL modems with private IP addresses on the RV042 WAN ports for various reasons (on the satellite office the DSL mode...

Good Day, I am in need of a small business router that has support to use VLAN over the WAN port as the service provider for IPTV and Internet are both sent over their network tagged as VLAN 34 (IPTV) and VLAN 35 (internet). This also needs to be a G...

Hello ... I just bought an RV320 and it is working great, except some specific forwarding rules I need ... Here is what I'd like to do : WAN1=74.x.x.179 WAN2=74.x.x.152 Port1=12002 Port2=5902 How to accept connections on Port1 only from WAN1 (an...

Hi,I have a rv082 router  and another router provided by the Internet Provider company with is the one with the Public IP. I can't put aside this second router because is providing not only internet but telephony lines so is necessary to use this sec...

Im replacing our RV-120 with a RV-320 and wondering if i can export the settings from my RV-120 to the new RV-320?

I bought an RV320. Everything is working great except for the VPN.I have configured an easy VPN connection to be used by Cisco IPSEC client. The client can connect to the local LAN but after about 30 seconds the router reboots. Even during the time t...

Hi,I am a bit new to setting up dual wan router. I am currently having a Zyxel P660 Adsl router but rv042 is unable to connect to the internet as zyxel doesn't give it a I.P address. Thank you guys in advance.   

We just purchased an rv180 for the VPN.  We currently have a netgear wireless router setup doing NAT and DHCP.  It connects to a cable modem to the internet.(Comcast)  I would like to keep the rv180 behind the current firewall and just forward whatev...

So, I have a recently purchased RV220W wireless router behind a 5505 firewall.  I have it running in router mode (no NAT), and I have allowed all services in both directions through the firewall configuration on the wireless router.  However, I can p...

Hello,I am trying to configure my Server 2012's remote access using ports 80 and 443 on TCP. UPnP is turned on and Server 2012 cannot configure the router, which is fine. I put the device on a static IP and set single port forwarding for both 80 and ...

Hi,I have made upgrade at my Cisco Router to Current Firmware Version 1.0.4.14 and I can not interconnect IP address with the MAC address now. It used to be there: LAN - IPv4 - Configure Static DHCP. But unfortunately a button "add" is missing now.Qu...

RV042 v3  WAN PPTP connection didn't work, but on the old RV042 it works, why ??

Need some assistance....I was able to configure these routers using static IP's without any issue on my inhouse network.Client doesn't want to pay for Static, so have setup DYNDNS account.so have setup advanced IPSEC with FQDNgetting initial handshak...

Hi there,Currently i have RV215W, behind the router is Windows 2008 SBS that runs Exchange Web Mail and Remote Web Desktop.  They are planning on implementing CRM solution on 2nd server.   My question is as follow, i need to redirect the traffic that...

Is there a SPC Compiler Tool available for the SRP520 & SRP520-U series routers