Routers - Small Business

Hello,I apologize if I am posting in the wrong forum for this, I was not sure if I needed to post to a security forum or not.I have setup 15 x RV180W's so far for a particular client.They have requested that we add a Corporate Wireless VLAN for their...

My SRP527W has never had its firmware upgraded since purchase. I had a need to do this recently, but could not find the section under Administration for Firmware upgrade.The only two items under Administration are Time Setup and Switch Setting.I've t...

Hi, I have the RV042 (firmware 1.3.13.02-tm) in Load Balancing mode. When I do a speedtest, the result is the total bandwidth available on my 2 connections, i.e. 8-9,000 Kbit/Sec (each line is approx 4,500 Kbit/Sec). When I stream from Netflix, the b...

I have a RV110W router and it is using PPPoE to connect to the Internet.All works fine except under the WAN setup page I'd like it to connect on demand rather than stay connected with the keep-alive timers.If I enable the connect on demand option the...

We've recently setup a RV180W to replace an older router  and are experiencing performance issues with WIRED clients, WIRELESS  clients seem to have no problem. We've updated the firmware (1.0.1.9) and the problem still persists. We only have a VLAN ...

                   I read somewhere that the security log could be set to display web address vs dns address.  How do i adjust this?ThanksCurtis

hi here is my setup :I am using the CISCO RV042 router to connect my phone system to a Sip trunk provider router and to extend my Lan segments so the phone system have internet access.i need it this way because i cant put 2 default gateway in my phon...

I'm trying to set up an RV042 as a gateway for our home network. I've cloned the MAC address of the cable modem attached to WAN1, and have set up WAN1 to obtain an IP automatically. The System Summary page shows under WAN Status that WAN1 has been as...

Hi Guys,I want to know how could I configure a Router Cisco DDR2201v1 for watching  my IP Camera System from anywhere with a internet connection. I already try  to open a port in the NAT virtual server configuration but it didn't  work. Could you hel...

We are running an RV220W at the latest firmware (1.0.4.17). Due to certain internal activity we had to add a few firewall rules. Once we exceeded 10 firewall rules we could not reorder them. The reorder page showed the first 10 rules OK, but when you...

I have 2 RV042 routers with identical firmware (1.3.13.02-tm) and settings. One router is a backup that sits in a box, but both experience this problem. The WAN port gives very poor performance most of the time. Download speeds range from normal, 25m...

Hi,Recently I have switched from DSL to Comcast Cable. In the PPoE settings you can disable DNS from ISP. However, now since I have to use DHCP I cannot disable the DNS from ISP.If I change the DNS on the LAN or change the DNS in my adapter properti...