Routing

Hi, I have setup some BGP communities for my customers to change the local_pref which are working however I wanted to know if the following config would work in reference to below config. Basically I setup a community called 6666 that will backhole ...

Hello I wonder if it is possible to check the status MTU value in ASR903 router modules using the platform command show ? If so it is possible this MTU value be changed?

Hi All, I am having issues with inbound access from network 200.200.10.0. Outbound traffic from 10.10.10.0 is working fine to 200.200.10.0 via NAT IP 193.50.50.103 I have attached config. Any ideas ?

Hi I'm working with a Cisco 819 4G/LTE (model C819HG-4G-G-K9) with modem Sierra MC7710 When the router attached to the UMTS mobile radio network I saw that the speed is 384000bit/s as showed below: Cisco-819#sh run | beg line 3 line 3  script dialer...

I am testing a CSR1000v on an ESXI host. Ive loaded a new ios image into bootflash, i used the boot system command and reloaded the router. The router comes back in the new ios as expected. However, if i issue a write erase to remove all congif, relo...

i have 3945 router , what licence do i need to activate MPLS ?

Hi Team, Where to get MIB files for below device, I checked in MIB locator, it is showing invalid image name. ISR4321/K9 Image : isr4300-universalk9.03.15.01c.S.155-2.S1c-std.SPA.bi

I have a cisco 7609 with sup engine 720, I want to implement VPLS for that I purchased a   7600-ES+20G3C    with  the adv license  76-ES+ADVIP-LIC in a separate pakCan you please help me how to activate the license on the 7609.

Hi all as per cisco config example : Load Sharing When Multihomed to Two ISPs Through Multiple Local Routers Load balancing is not possible in a multihomed environment with two ISPs. BGP selects only the single best path to a destination among the ...

I recently got a Cisco Switch 871W - I finally got it configured to my imac, but when I go into it to reset the admin password within the GUI it doesn't reset, and when I go into the terminal - I am not seeing it as it boots up. Does anyone have any ...

Hi, Just saw that udp/161 was open even though we have an ACL on snmp community -WHY IS THAT? SNMP is closed so that i cannot do a snmpwalk, but it's concerning that udp/161 is still open. snmp-server community ********************* RO SNMPACLsnmp-...