Routing

In this scenario a router running 15.2(4) is dual connected to two others using an EIGRP as the IGP.  It is receiving the same network 10.0.0.0/8 prefix from both neighbors.  When this route is injected into BGP using either the network statement or ...

hello, I am going to try and set up a VPN connection for the first time (newbie).I will be conifiguring my 2801 router which accesses the internet via a WAG120N cisco ADSL router. At the other end I will be connecting with a Cisco dektop VPN client.I...

Hello,Is it necessary to do MD5 between eBGP on p2p private link?thanks,chanty

Hi guys,We want to connect one of the CE routers to two our PE's (active/standby, no loadbalancing) and use dynamic protocol for route exchange.Both PE's and CE share the same subnet.What are our options? Can we use HSRP, make one PE active and align...

Hi there, I have a strange problem concerning a Cisco 3925:Cisco IOS Software, C3900 Software (C3900-UNIVERSALK9-M), Version15.1(4)M, RELEASE SOFTWARE (fc1)(c3900-universalk9-mz.SPA.151-4.M.bin)This router has 3 native interfaces: Gi0/0 (RJ45)Gi0/1 (...

Hello All, I need assistance in shaping bandwidth over DMVPN. I tried to configure some QOS policy but it doesnt detect properly. Here are my Ranges : DMVPN Tunnel = 192.168.100.0/24Inside Network Range = 10.10.10.0/24Remote Server accessed over DMVP...

We have OTV working on our ASR1Ks in a lab environment. We mocked up two data centers and a simulated ISP core that supports multicast. Everything works fine. We can move hosts between data centers, drop a few pings and see the OTV table updates and ...

Hi,I am trying to add additional block of 4 public IP address to UC540.When trying to create NAT pool, i am receiving error the new range is not in the same subnet as WAN.Current WAN subnet is /30, but new block of IP's change after first 2 octets.Ob...

Hi,I've got a full t1 circuit problem I cannot resolve. I don't manage the device at the other end of the circuit.  Config for both of my routers is the barest minimum on both routers:!interface Serial0/0 bandwidth 1536 ip address xx.yy.xxx.zzz 255.2...

I'm attempting to install an IOS image (about 53 MB in size) on the flash of a 2811 router, however the transfer times out after 32 MB have been transferred. I've tried two different tftp server software packages with the same result. Does the tftp...

Hello, I have a Ethernet module (SM-ES3G-16-P) installed in a 3945 router and noticed during first boot no licenses are active at all. I would assume at a mimimum ipbase would be active. With this module, does static routing work with just ipbase?Exa...

   From Router 3925 which it has SM-ES3G-16-P etherswitch module from that module we have connect three more router in which is in different locations. I configured switch module and other end router i am able to ping each other. But i am able to pin...

Hello! I have configured 1700 series router to forward workstation traffic through one port and the voice through another. The Configuration is pretty straight forward, but we experience a major problems. When the SIP phones plugged in to the switch ...