Routing

Hello,We have had a 50mb fibre line put into a remote office, when we copy a large file of 2gb in either direction we get nearly 50mb constantly, if we copy small files equivalent to 2gb then traffic only hits only 30mb.  This is TCP traffic, why wou...

I have configured Cisco 1841 router. My problem is what if every first time a user opens the browser will display a web page server. My web server ip address is 10.10.1.5.  My router configuration :hostname mumtazenable password mumtazenabled secret ...

Hello Community,Can someone please let me know how to stress a GNS3 router in order view an increase in its cpu usuage?CheersCarlton

We have an MPLS network. MPLS is handled by Telecom vendor.Each of our spoke sites peers with a single Telecom BGP peer (CE-PE).We would like to enable Multicast on our network. We thought using Multiprotocol BGP Extensions for IP Multicast which see...

I have two 3825's. Each has it's own ISP connection. Nat is configued for both. They have an ethernet connection between them and I'm running OSPF between the two so the routes propogate. I have qty 11 Dialer interfaces configured on each router (eac...

Hiwould you pls help me to understand the below  in red?ThanksIbrahim

I'm having an issue where internal hosts cannot access the internet but I am able to ping external hosts when I console into the router. The router is a 2800 series. Does anyhting jump out at you?Thanks in advance.version 12.4no service padservice tc...

I have the following set up, at one of our sites:What I would like to do is take non 10.x.x.x web traffic, and pipe it through the ISP2 link, and keep all other 10.x.x.x traffic over the main ISP1 link.  I would like to set this up on the L3 3750's t...

Hi,We have configured CPN in our Cisco 2911 router. I have 4 VLAN in my network. I sucessfully created the tunnels. From 1 VLAN I can able to access the resouces through VPN and not from other VLAN. Below is the configuration of my router. Any one su...

Hello,Here is my client's network diagramInternet connection-> firewall -> router-> switchThe outside interface of the firewall is connected to the internt with static or dynamic public IP address; The private IP addresses are configured in the insid...

Hi all,Hope you can help me out to try to automate the backup in the following scenario:The main circuit is a 10Mb MPLS link with my ISP propagating my routes using eBGP and as a temporal solution, I'd like to implement a site2site link through a DSL...

Dear All,Trying to figure this put and really struggling. If anyone can offer any advice it would be much appreciated.The scenario is this:- the WAN consists of a in-house satellite network using comtech CDM-570 IP-Enabled Satellite Modems- there is ...