Routing

Good day!Can anyone tell me if i have 2 type of license on my 2901 router: ipbase and uc, will the 2 type of fuctions of this license work at the same time. Another words will i have route and nat funtions work with voip having to type of license on ...

I have a customer connection that I can't change, but I need to connect my network to his.I have a 6509 as my backbone switch with 100's of vlans configured in it. Here is the configuration of the port I am connecting to the customer switch.interface...

Hello. I'm sort of a newb at all this, shooting for my test shortly and what I have set up on packet tracer (just so I can get some practice setting up Wan configurations with a few routing protocols in.) a network that looks somewhat like this.On on...

                   Hi ,                         we are deploying IPT with voice gateway router 2811 having this IOS ....{ 2800 Software (C2800NM-SPSERVICESK9-M), Version 12.4(15)T9, RELEASE SOFTWARE (fc5)}My qusteion is that is this IOS support voice...

Hi. I want to Load Balance using my Cisco routers.Router 1LAN IP: 10.0.0.1 255.255.255.0WAN IP: auto-negotiadedip route 0.0.0.0 0.0.0.0 Dialer1Router 2Here is the Problem. This router get internet from a Wireless Bridge.The Wireless Bridge device, is...

We are now upgrading our service to AT&T AVPN service ( 2t1). What are configs?thanks,alison

I have two dedicated T1's for Voice in a multilink to our main office where the IP Phone switch is located.  I am getting sporadic complaints of muffled voices and I am seeing Error Secs and Slip Secs. I have opened a ticket with our provider and aft...

How does one go about enabling this feature below:c3845#show process cpu history table%CPU utilization history table is not enabledc3845#Thanks.

We are in the process of adding an additional ISP to our corporate network.  When we do so the ASA we use will connect with our WAN sites (Cisco 2811's and I know we need to upgrade!) with the current NAT'd IP (7.7.7.7 for this question) and also the...

Hi AllI am having issues with running  IS-IS between my ASR9006 and Cat6500 switch.I am running IOS XR  4.0.3 with Mini and MPLS packages enabled. My configuration on ASR is below, please can someone confrim my configuration on the ASR9000 is correct...

Hi,I have a router working as PPTP only, find the config attached. Everything is working fine accept that it restarts from time to time (around 30 minutes). Checking the crash info, I found that it's a software issue. I tried to upgrade to several IO...

Good afternoon everyone,I'am a bit newbie at using Cisco products and here is my problem : I have set up a VPN tunnel between 2 Sites (A and B) a few month ago using 2 cisco SR520-ADSL-K9. All was working fine until power failures occured on the site...

On the Cisco ONS routers, is there a relationship betweenspr station-id 1 on the SPR interfaceandspr interface-id 1on the POS interface?I am a bit new to this system