Routing

I am setting up a two T1 multilink on leased lines.  SInce the site has VoIP I want to set up the Multiclass.  I have applied the following configurations:!interface Multilink1 ip address 172.23.0.17 255.255.255.252 ppp multilink ppp multilink interl...

I am trying to connect two LANS together 172.16.2.x and 172.16.1.x. I am able to ping from ASA, but not from a workstation. I am new to Cisco products so any help is greatly appreciated.: Saved:ASA Version 8.2(5) !hostname sanfranciscoasaenable passw...

Hi. I've been working with a company in the UK to get a PTP connection setup between Minneapolis, MN and Chicago, IL. At each site with have a ASR1002. The connection is made via a fiber connection from Level 3. Level 3 is just handling layer 2 and w...

What is the difference between HWIC-1ADSL-M and HWIC-1ADSL without the "-M"?

I have tried to change the username and password using the following procedure but when I do so and reboot the router and try to login using the new userid and password it says Authentication failed. What am I doing wrong?Complete these steps in orde...

Olla,Please I need some advice and suggestions on designing a WAN. The  scenario is thus:there exists a head office, 6 zonal offices and 89  branches that are all to be connected on the WAN. please note that data  transfer is a key activities on this...

hi! I've a main connection using mpls to our corporate wan, and a backup link using cisco ASA + one link to the internet. The backup link to corporate thru ASA tunnel will only kick in when the main mpls line failed.I understand that i can use floati...

Hi,I have a cisco 1841 router in place. I also have a ADSL module which fits into the cisco router. My understanding is that if configured correctly, If the primary circuit were to fail (Ethernet Circuit MPLS), the ADSL would take over services until...

Greetings,How about on the 3725 router? A couple specific questions I have while configuring the portion for IGPs. Here is a couple snips of example configurations I'm finding on the Internet, that I have questions on. As you can see there are severa...

Hello,I have two VRFs: global and local. R2#sh ip route vrf global | begin GatewayGateway of last resort is not set      100.0.0.0/24 is subnetted, 1 subnetsB       100.100.100.0 [20/0] via 20.0.0.2, 00:50:48     20.0.0.0/30 is subnetted, 1 subnetsC ...

Hi, I can not apply the LLQ to ADSL ATM interface. the system take the command with out any error message, but no in the show running config. Any idea or Cisco link can explain this?class-map match-all control match dscp af31 class-map match-all vo...

Hi Experts,i'm trying to accomplish the following:(please look at the attached image).I want to trasport a bunch of vlan layer 2 etherchannel on a pair of layer3 connections, using L3 to load balance.i was considering a pair of options:1) bridging + ...