Routing

I'm planning to implement PAT on the Internet router, what's wrong with the pat configuration below:ip nat pool Finance-Pool 74.74.74.101 74.74.74.101 netmask 255.255.255.252ip nat inside source list Finance-Range pool Finance-Pool overloadip access-...

Hi,We currently installing 877 with 7960 phones to our customers. Since 877 is end of life, I'm testing 887 to replace it. However, the 887(CISCO877-SEC-K9) we bought to test came with c880data-universalk9-mz.150-1.M6.bin.We bought this product since...

Dear friends .. first of all sory .. m opening this again .. as i thought i got my answer in my previous discussion but it didnt worked for me .and i already closed that by marking answer..my scenario is ... i have 1841 router on which i am having pr...

Hi ,          I want to implement QoS for Video Conferencing Traffic on Cisco 3660 RouterPlease guide me. Because I am facing lots of voice crack and frame delay whileVideo-conf...Regards,Subash Varma

I'm trying to figure out the best design for my network. I currently have a setup like this:Internet - Cable Modem - Pix 515E (doing NAT) - 2621 - Internal NetworkNow, should I have the 2621 as my edge device or the Pix? Just trying to get a good des...

Hello,I am trying to configure an IPv6 LISP ALT between and IOS router and an NXOS router but the BGP session to propagate EID prefixes  didn't stablish.IOS Configuration: vrf definition LISP rd 1:1 ! address-family ipv6 exit-address-familyinterface ...

Hello, I have an interesting problem to establish OSPF adjacency between several routers. Routers are interconnected via transport SDH / PDH networks, in a way that all router interfaces on the same subnet. The traffic over the transport network go...

when i try from branch office 2 to reach branch office 1 lan, spoke to spoke tunnel establishes dynamically and works absolutely fine.when i try from branch office 1 to branch office 2 lan, it goes to hub instead of reaching the spoke 2 directly.The ...

I have a cisco 3560 switch set up as my edge router.  It is working as my external demarc switch and edge router.  It is sitting between the ISP's switch and my ASA firewall.  It's a very basic configuration with port 1 set up with a fixed ip and swi...

Hello everyoneI have been checking the following Log on 2900 Router:Nov 28 09:10:28.582: Se0/1/0 PPP: Using default call directionNov 28 09:10:28.582: Se0/1/0 PPP: Treating connection as a dedicated lineNov 28 09:10:28.582: Se0/1/0 PPP: Session handl...

I have a second link being installed this week to a second ISP.  Each ISP has tunnels that terminate on there routers for various services.  Right now on the 6509 I have a static default route which sends all traffic to ISP one.  Once I get the secon...

I have a few remote routers connecting to the home office using GRE-VPN and using OSPF for routing.The routing is working properly except for the traffic being sent by the routers directly ( logging to a remote syslog server ).I can ping the remote r...