Routing

I have 1 2821 router with several IP addresses from a single provider.  The IP addresses are not contiguous.I would like to NAT different internal subnets to different external IP's.  i.e. map 10.1.1.0 to x.x.220.68 and 10.1.2.0 to x.x.220.70 and 10....

Firstly i hope this is in the right forum.I have setup a cisco 877 router at our branch office and setup a vpn to our head office which works ok but the internet will only work if the vpn is on.The vpn drops frequently at the moment so the branch off...

Hello,We just put a ISR1921 in one of our sites and we ran into a problem. We have this router that make a "load-balancing" between 3 modem/router from our ISP on 3 different ADSL lines. Except that with 2 lines he can, with 3 he cannot. This TOTALLY...

Hi,I have a question about filtering incoming bgp route updates from an internet provider. This provider sends the full internet routing table and default route and on an incoming prefix-filter on the customer switch (C6509-sup720) the default route ...

Working to replace hub-and-spoke (router-to-router) individual VPN tunnels (GRE/IPSec or VTI) with DMVPN but without using default-route.  Default-route doesn't lead to the next-hop the hub should use for  spokes.  With individual tunnels, had indivi...

Dear All,At presently we have 1 core IPSec router where all the branch traffic is terminated and its the entry and exit point for all the traffic traversing the Data center. We need to implement 1 more IPSec core router which we need to plan in Activ...

Hi all,I need to configure a load balance based on url filtering:All the traffic sent to https://home/can should be load balanced on a group of server (eg. x1, x2, x3); while all the traffic sent to https://home/can/<any-sub-directory> should be load...

I have this network setup:remoteR0------- GRE/IPSec (eBGP) ----------- < HubR5 -----------CoreSW (iBGP/EIGRP) ------ HubR1 >--------- MPLSI have networks in remoteR0 that I advertise via eBGP to HubR5.HubR5 received it and redistribute it via EIGRP a...

Hi Experts,This is a new assignment i got. right now all these devices are iin 192.168.1.0/24 network.This network is in remote location. I may get an onsite help. Now all the devices are connected to each other in a rapid manner.They are some how ma...

Hi Dears. i have a one nat  problem at my router. all my nat translations are ok except one nat ttanslation: here is problem  at nat configuration.ip nat pool AZCARD_NAT_FTP 192.168.182.2 192.168.182.2 prefix-length 24ip nat inside source route-map M...

Please go through the attached doc and suggest the needful.

Hi Expert,Anyone has ever seen the error message about %ROUTING-BGP-3-BUF_TOO_SHORT please help to share idea to solve. I found this error on CRS-1Thanks