Routing

outsideA    B \   /  R   |insideR=2801 Router, A and B are the WAN links.While having a dual WAN interface is normally not an issue, both of the links use DHCP, so when you attempt to place a track stament on the route, it's not an option if you incl...

Hi allOn some of our ASBR machines (6509 with Sup720/MSFC3) I have strange BGP behaviour:Issuingsh ip bgp neighbors A.B.C.Dyields the information that I am not sending any prefixes:[...]                                 Sent       Rcvd  Prefix activit...

Hi all,sorry if this is in the wrong forum but I need to look at options for terminating multple ADSL2+ circuits in the UK.Is it worth investing in a router to terminate multiple connections? Or do you think I could just use multiple 877 routers conn...

So...http://www.cisco.com/en/US/docs/wireless/access_point/1130/quick/guide/ap1130qs.html#wp39091step 1 : configure terminal    enter global configuration mode           hahhh its not easyI see the hyperterminal on the console port*Mar  1 00:00:06.28...

Hello Everyone!!I have one router with two conections to IPS´s and two connections to lan, so I think in route-map. but when we did the change, we had some problems with the communication in one of the route.this is the situation:1. All the traffic o...

I have been looking at google to find out the values for Mean Time between Failures for some routers but no luck, coz i have to finalize the Service Levels and the Architecture of different type of sites. Can anyone please help me and direct me to a ...

We have 2 T1's to different ISP's. We use EIGRP to do outbound load balancing. This is done 1 hop internal to the ISP routers. This works great outbound, but obviously does not work inbound. It hasn't been a problem until recently and now most of...

Hello All,We have following scenario in internet block at one of our enterprise customer,2 * ASA firewalls (Active/Standby) ------L2 Switch------- 2 * Internet RoutersOspf is configured among ASA and internet routers. Each router having 16 Mbps link ...

Hello Networkers,I would like to know whether there is any mechanism to monitor route , the reason is when we have a link flap on the primary circuit normally the traffic flows through backup circuit but when there is continous flap on primary circui...

I Have a setup using DMVPN between a hub and about 18 other spokes. Direct spoke to spoke connectivity is allowed also. The transport for the connections is the internet, so each site has a default route to the ISP and the VPN is established from the...

Hello,Customer is using AIM-ATM AIM with a VWIC2-1MFT-T1/E1 card installed, and using the E1s in ATM mode.They have recently migrated to ISRG G2, but; ISR G2 (2911) dosen't support AIM Modules, and there is no relevant module for ATM.So is there anyt...

hisuppose i have a vlan 1.1.1.129/29if i advertiserouter eigrp 1passive-interface defaultno passive-interface vlan 10 (1.1.1.129/29)network 1.1.1.0/24My question is will it still advertise /29 as under network command i have advertised classfull /24i...

Hi,in my scenario the branches are connected with multiple ispslets say X is advertising its route to both ISP's from 3 exit points ,1. when this route is reaching at Router C through ISP-B , i am blocking it to advertising it to ISP-A form this rout...