Routing

Hi All,First post on the Cisco forums.... so hi to everyone here, looks like a great community!I would be interested to hear peoples thoughts on a design I am currently working on, essentially we are starting to move a lot of our customers into the d...

hello guys , i wanna know if it is possible to make more than one Site to Site VPN tunnel using the same serial interface and different destinations ...

We have disconntigious non-backbone area.Can we configure virtual-link through backbone area

Dear AllI have a simple set up with a hup GRE/NHRP and a spoke. the spoke has 2 WAN interfaces, f0/0 has a public IP and the GRE tunnel works fine.The spoke f0/1 gets a private IP from a non cisco VDSL router/modem. On that side the GRE tunnel will n...

HiI'm looking for Cisco documentation with best practice guidlines on how to setup a new POP connecting into an existing MPLS network using OSPF and IBGP in the AS.Regards,Werner le Grange

I am looking for suggestions to help me understand why I'm seeing a high rate of fan failures on my routers. I manage 1500 routers, comprising 2821, 2851 & 3845. In the last 7 months, nearly 4% of these routers have exhibited a fan failure and I thin...

Hi Folks,I need a  little help, how do I nat from outside to inside? I need to allow connection to my outside ip address from SIP provider and then pass it to the sip server which has a private/internal.Thank you in advanced I appreciate it.JP

hi,I've created 2 sub interfaces and connected links on that. But i'm unable to get statistics on those sub interfacescan someone help me on this..thanks.... S

Hi,I have a Cisco 2651XM router with two built in FE interfaces. Please, I just wanted to know if I could add another FE interface.Listed below if the router details:cisco 2651XM (MPC860P) processor (revision 0x200) with 125952K/5120K bytes of memory...

Hello Dears,      I have the following situation on a router. I have a mail relay agent(10.0.0.5) and I have to translate port 25 of my global address x.x.x.x:25 to it. The mail relay agent sends the received mail to the mail server which has the add...

Hello EveryoneI am looking to reduce the % of b/w utilization of outbound traffic if it uses the following ports:3600137-139If possible, I would like to set the rule for a specific server: 192.168.17.39Can this can be done through QoS policy map?  If...

i have 14 acces points and 65 destops ( windows xp ) and 14 laptos ( mac ) , I tried to do upgrade in my security , wep - wpa2 personal , but when i do the upgrade the wpa2 dont work in mac computers , wahts is wrong with this , canot conect or is so...