Routing

First off I am a systems engineer guy, not Cisco although I can get around and do what I need to do in a switch. We are working on taking a port off of a switch and connecting it to a mux (TAC 900). Port is trunked to another switch in another geogra...

I have a customer that only requires 56/64K connectivity at branch locations for a MPLS network. We have previously quoted 1841 series routers with a CISCO 1 PORT4-WIRE,56/64 CARD, WIC-1DSU-56K4 card.  I cannot find the same card for the new 19XX rou...

I have a 3560 switch 48 ports ios version 12.2(35)SE5I want to run two data vlans on the same port.  Currently the port is in access mode and set to vlan30 I want to add vlan 40I wanted to use multi mode, on this switch not an optionbut private-vlan ...

I have configured an Cisco 881 router in our lab with netflow commands and pointed to our network monitoring tool and I want to check if the tool can collect valid traffic statistics from this router (eg. utilization).  The problem this router has no...

Hey guys,i have a Cisco 1841 with Hwic 1-t (IOS 12.4(15)T12 ).i want monitoring average load of my HDSL.How to can i monitoring my bandwith in upload and in download for WAN interface ?Any help ?thanks to AllStefano

Hi,Imagine a 5,000 employee organization distributed across two states.30 sites all connected via Private Line with old, end of life and unsupported routers. IT folks are making a case they do not know whether they should invest in MPLS, since Privat...

I work in a lab and we are developing/testing a server based system that dymamically calulates routes for certain types of encryptors:That said part of the component involves redistribution from ISIS into RIP (yes the only prot avail) on these encryp...

Hi,Im looking for MIB for monitoring 6500 line card from availability prespective;Regards,Raj

I  would like more information of performance to 7600 router with the  SP-720, someone has idea of how many sessions full bgp routing it  supports? I have 4 links 1 GB and a throughput of 900 MB.Need  to get about 8 sessions full bgp routing (he owns...

Hi,I would like to know is it possible to assign multi subnet into same VLAN.  Exampleeth0.0 - Vlan 10 - 192.168.10.0/24eth0.0 - Vlan 10 - 192.168.20.0/24eth0.0 - Vlan 10 - 192.168.30.0/24.........Thx!

Real quick question.  I have been searching all over for this.  What is the maximum number of VRF's supported on a 4900M running 12.3?Thanks.

Hello!There is a port on 3560E, facing POP, this port is in the dedicated vlan, that is terminated on 7606 on SVI (peering point).There is configuration made on the 3560E port, that prevents storm of ucast or bcast kind. This is: switchport block mul...

BGP Gurus,I've trying to setup a filter to local pref a particular AS # on my routers with your examples and have not had any success. After implementing them I did a soft and hard bgp config. Even did a hard shutdown on the session to see if that wo...

Dear SirI am new for OER feature. My network topology is I have one internet GW router (2811), I have 2 x WAN (ISP A and ISP B) and 2 x LAN. LAN 1, I use for my Web Servers only so no any controls on this LAN 1, cause from LAN 1, I use Internet IP AD...