Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Has anyone had any luck with this setup? I remember trying it a number of years ago with no luck, don't really remember the details it was so long ago.Any sample configs would be appreciated.I would have one router with both the T1 and DSL interfaces...

miked by Level 1
  • 1110 Views
  • 5 replies
  • 0 Helpful votes

HiNot much familiar with CATOSwhat command allows to check interface details on CATOS, module #1 48 port 10/100/1000I m interested in getting details for int giga 1/5

I am currently working for a client and helping them redesign part of their network.  The client has a pretty nice network scheme in that they have their Headquarters connected to their Disaster Recovery site with an MPLS circuit, and then also a Fra...

Resolved! Corrupt IOS

I have a 3750G switch that has repeatedly developed a corrupt IOS file. It has happened 5 or 6 times this year after which I would reload the IOS and then everything will work fine for a month or so, then it happens again. Can anyone tell me if they ...

Dear All Expert:Hi, I have a small network query and wish to get some clarification. My company have "Router A" and "Router B" at 2 location running iBGP between them and each of the router running eBGP with 1 upstream.Problem is both router receive ...

victorcom by Level 1
  • 3229 Views
  • 6 replies
  • 0 Helpful votes

Hello,I need advice on how to make use of the two Internet accesses we have/need.Now we have two separated networks that we need to join. We'll use different VLANs and we'll route them with the Cisco 3560. Now the doubt, is how do we have to configur...

Hi all,I am trying to limit the bandwidth to 10 mbps for one of my customer on 3550 switch.My configuration as follows but its not working.mls qosip access-list extended upload permit ip any anyclass-map match-all INPUT  match access-group name uploa...

Resolved! Routing Problem

HelloSeeking help for routing issue,Primary route for R3 to reach R1 is via SPBackup route for R3 to reach R1 is via R2When backup link is up then packet drop is noticed from R3 to R1R2----------------R3---------(service_provider)-------------R1R2---...

How does QOS bandwidth work?ExampleIf traffic going from my CE to PE requires 5mg of EF1 and traffic from my PE to CE also requires 5mg of EF1 does this mean I need 10mg of bandwidth or are the two queues separate?RegardsDave

Hi,I'm try to setup a Cisco 867 using two PVC. So what I need is one ATM interface, and two virtual ATM's, ATM0.1 and ATM0.2. And als two Dialers. Can anyone help me with the command order to achief my goal?I have found several config layouts (show r...

we are going to use cisco 1841 router. i want to configure leased line inthis router .i will be connecting the local lan in fast ethernet 0/0 with ip 10.10.10.1 subnet 255.0.0.0 and i will be connecting the leased line in the serial port with ip 94.5...

Hi,I have Cisco 3845 with VWIC2-1MFT-T1/E1 card. I would use this card for ISDN backup (data traffic).When I put pri-group timeslots 1-31 on interface controller e1 0/1/0 I got an error:% Not enough DSP resources available to configure pri-group on c...

vjemin by Level 1
  • 1983 Views
  • 10 replies
  • 0 Helpful votes
Unanswered Topics