Routing

Dear All,        as per the attached diagram:eugmar50 is connected to eugrsr50 via E3 multilink interface , when i treid to move eugrbr10 link from eugrsr30 to eugrsr50.then , the ping to loop back of eugrsr50 is not stable although the same link wor...

Dear All,        when i connecting serial cable on S0/1 on this router , the ping delay is very high and then s0/1 is up down although the same link working on another router without any problem.

Hi All,We have a working IPSEC tunnel to another Provider to encrypt everything going to 10.109.x.x - this works great!!I've added another IP range 192.74.x.x to go via the same IPSEC tunnel but can not see the packets being encapsulated and encrypte...

hi ,When i am switching on the router i am getting the output :" system bootstrap, version 11.0(10c), softwarecopyright (C) 18601996 by cisco systemsBad memory      -     wrote zero , read 0x00000900 at location 0x00000010 "what would be the problem ...

Hi,I have a cisco 2821 connected to a server with ip 192.168.157.253 and all traffic goes to this router.This server only uses this router.  There is another cisco 1841 router with 192.168.157.254 ip and all servers use this device.When I open a term...

Hi, I have configured the PXE Server with Symantec Solution on Windows Server. The PXE clients that are working on same subnet they are working properly. I have PXE clients working on different subnets, they are using WAN connections but they can’t ...

Hello All,Wanted to confirm maximum E1 ports supported on 2811 without any performance degradation.2811 has 4 HWIC slots, i need 8 E1 ports to be connected to different sites.if i populate all 4 slots with VWIC2-2MFT-G703 which makes 8 E1 ports, Any ...

Hi all,Is it possible to configure 64kbps channels on the SPA-1XCHSTM1/OC3 card on an 7613 with the kitlist mentioned below ? ProductDescriptionQuantity7600-SIP-200=Cisco 7600 Series SPA Interface Processor-2001MEM-SIP-200-512M512MB Memory for 7600 S...

I have tried this configuration in a small lab environment and it was working fine. The web server was running at 192.168.200.2 address.Planning to try this at my customers site, but I do not know if there will be problems with DNS or something else....

Hi,i have two 10Mbps point-to-point metro ethernet links to my branch office. bothe the links ate terminated on separate router to achive hardware level redundeny.How can we achieve load balancing and redundancy on both the routers ? what tech i can ...

Hi Everyone,My company is about to embark on a colocation arrangement at a carrier neutral datacenter with a DR site.We will require a connection between both sites and our central office. For this we are considering Metro Ethernet.We will be hosting...