Routing

HelloCan I get some assistance Site_A connects to Site_B via outdoor wireless. Wireless link terminates on 4500 on both SitesHow can I extend the VLAN5 on Site_B (Vlan5 is defined on Site_A)I need to connect 3 server on Site_B with vlan5 ============...

cisco 7604 has no card in slot but is showing config...how can we clear that...is there a command like no card type

Dear All,I configured QoS for remote branches the bandwidth link is 256 so i need to configure frame relay fragmentation but when i configure it under the sub interface the router hang and to solve the problem i should delete the fragmentation to acc...

Dear All,Please help me to find the port utilization on Port Channel interface,With Commands.ThanksTabrez

Hello ExpertsSetup isAccess_SW===========Core============ASA===========Internet_SW========(( I N T E R N E T )))Requirement      :     Allow Guest Users for  Internet Access Access_Point     :     Cisco APHow can I allow guest users to access Interne...

Hello,If you could help me, it would be great.I am trying to route the following segments(each distant location) and do not know how to route A from/to C.Between A and B is kind of secure line provided by my ISP. ISP controls source/destination segme...

First I apologise if this is in wrong location but I am stumped.   Using SDM when I go through the firewall wizard and choose basic firewall, and choose low security, even though it detects my WAN outside interace as dhcp client and prompts to allow ...

Dear All,              i have two ILL from different ISP , one is 2 Mbps fastethernet0/0  connectivity and another is 1 Mbps serial connectivity on cisco 2811 .  i want to combined output of 3  Mbps from both link from another fastethernet fa0/1. so ...

We're moving to ASR and OC3s instead of 7200VXR with DS3s.  I have a question about the BITs ports on the RPs.  I have BITs connections, but I also know that the internal BITs clock is stratum III and our BITs clock is stratum I or II.How do I config...

hi,I am phasing a problem in RAS cisco 2500, when its boot up , it  stops at  "Rourter(boot)>" prompt whereas in others it stops at "Router>" what would be the reason and whether it could be resolved or not ,if yes then how..tks...mitra..

HelloHub is connecting to 5 Spokes over IPSEC and 3 over IPSEC_GREHow to get bandwidth usuage for each VPN Site from Hub(Scenario 1)Hub connects to Spoke1 over IPSECat Hub its a Router and at Spoke its ASA(Scenario 2)Hub connects to Spoke2 GRE over I...

Hello,I have just received my new Cisco 871W router and I need to configure it to be to dial to cables modem using L2TP or PPTP in order to make a connection to the internet.I can see that in CP Express there is only PPPoE and there is no L2TP or PPT...

I have a Cisco 7206 router connected to (2) Cisco 6513 Switches:  Basically,7206----G1/1---------------------------G9/4---6513A7206----G1/2---------------------------G9/4---6513BBoth interfaces are running eigrp and every couple of days or week, the ...

We have a 2921 using two Ethernet ports for dry DSL coming from a third party ISP.  The ISP is stripping the usual DSL protocols and sending us only the Ethernet to this far end router.  The near end router is being sent only on Ethernet connection f...