Routing

Hi,I have a problem with our 2 branches accessing http port. Let's say Site B can't access the web server in Site A but Site A can access the web server in Site B. In site A we have Cisco 2811 Router and a Cisco 3560 Core Switch, on site B we have a ...

Sir,      we have configured isdn pri as a dialup in cisco router to remote users for accessing lotus domino server(for mail access) from our end.whenever a client access my end lotus server through isdn dialup,then they are downloading only few mail...

Hi,I need to interconnect two datacenters through a IP/MPLS network. I need to exchange the DB information between them and I see it's possible to use the EoMPLS technology for.The problem is due to the fact that I don't have the SPA module with SIP ...

Hi,i have two asa firewall in LAN based active/standby failover and two 4507r switch in HSRP.I want to configure the NTP to syn these network devices with my NTP server.PLease suggest..Thank YouChetan

Hi,I have trouble setting up a cisco 2811 as a terminal server using HWIC16A card and an octal cable.The problem is that for some lines it works, and for some it does not even though they are setup the same.When I do show line this is the output:Rout...

Hi all,I am facing a peculiar issue with ISAKMP initialization.I have configured Pre-shared keys in "derby" router to get registered with "KS" router.Issue: "derby" is not able to initialie the SA saying "no pre-shared or cert key available for peer"...

Hi AllCould you please look at the attached diagram and see if what I am attempting to do is possible and if so could you provide some pointers please.In the diagram I have two routers connected over the corporate WAN/Internet, each router in a diffe...

in our company.when we update cisco 7507 to cisco 7606. and ATM port update PA-A3-OC3SMI to PA-A6-OC3SMI. but now,the CRC of the ATM port increase,the counters is almost 60~70 for running 4days.WHY?

So we have a Cisco infrastructure. We have Cisco 2800 Series at our main building - "call it main building" - and Cicso 3560 PoE switch. Another site - call it "site B" - is the same with 2800 router and 3560 switch. At site B, users would report los...

I have the following config on a Cisco 877, and am having problems sending large packets when NAT is enabled - I have tried disabling ip virtual-reassembly, but it does not resolve the problem(And show ip virtual-reass does not report any dropped fra...