Is there a way to limit the sessions on ip basis or something else? And can we also apply time ? I mean at night the QoS is removed.Thanks
Is there a way to limit the sessions on ip basis or something else? And can we also apply time ? I mean at night the QoS is removed.Thanks
Hello,I am seeing the following error in in my router which is configured with EIGRP Protocol.Can any one tell me what are these logs about.Sep 29 00:41:56: %DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 10.3.250.18 (GigabitEthernet13/24) is down: retry lim...
Hi,I have MPLS link between India and US. I have configured BGP. Beside this, I have created GRE tunnel on these two point and publishing few EIGRP routes on GRE tunnel. The problem is whenever my physical link on India side is down, it shut down the...
Dear all,a basic question can i use the listed ip schema for to different networks or i have to be subnet specific for network s wise10.80.10.129-10.80.10.158 255.255.255.224 10.80.10.161-10.80.11.30 255.255.255.128
Dear Sir,we are facing problem with redundancy for our two internet links, We have 1hsdl card installed on cisco 2811 router and create bvi interfaces for connectivity, while tesing with ISP we had made below obervation:-when I am shutting the bvi1 ...
Hi,I am trying to find best & least expensive way of connecting one of the sites with our corporate HQ for the purpose of data transfer via FTP. the file size would be around 500MB.Our HQ is having an MPLS cloud connection. but this remote site doesn...
Hi. Please understand my poor english. - OSPF Network link1 +----------+ 10.2.2.1/2410.1.1.1/24 R1 + + R2 +----------+ 10.22.22.2/24 link2 - R1 have network 10.1.1.1...
- What is the effect of removing the SPAN session used by the FWSM installed in the C6513 switch (no monitor session servicemodule).- Is there an IOS for the 6513 switch that support configuring more than two SPAN sessions on the switch? As the switc...
Gurus,I have this setup on my network;ClientA-EBGP-MyRRCllient-ibgp--R1--ibgp--R2Will ClientA advertise routes be received by R2? since R1 recieves this thru ibgp but an RRClient.Thanks.Jeff
I need to replace 7206VXR NPE-G2 by 3845 for some reason. I'm concerned that it should not have any impact on RT voice traffic for some of the sites. How can I compare the performance between the two in terms of how much real time traffic can each ha...
I use ethernet cellular radios to which the carrier assigns static non-routable class C IP addresses. Traffic initiated by one of these radios is also routed by the CARRIER to two other class Cs.I would LIKE to attach one of these radios to an 1841 c...
I was wondering if someone could clarify this for me?Let's say Source host and destination host are the same distance apart for both scenarios. We'll say 100 meters.We'll also say there are no networking problems and the same amount of intermediary n...
I have 2 links between my data center and my DR site. They are both 150mbs lines. When I lose one of my links (VLAN264), which is the primary path, the other path (VLAN254) never becomes the preferred path. I can't the MSFC's on the DR 6509's to rout...
Hi everybody, Sorry about this simple question but i didn't find information about.I configured a PPP Multilink interface using 2 serial interfaces: one of them is at 960Kbps and the other one is at 2048Kbps.In order to verify total capacity of multi...
Hey guys, I have a 7206VXR router running (C7200-ADVENTERPRISEK9-M), Version 12.4(20)T1Over the last couple of days it's dropped the EIGRP routes (DMVPN) to all my branches. When I do a sh ip route 10.X.X.X it doesn't show anything except for a few ...
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
| Subject | Author | Posted |
|---|---|---|
| 12-04-2025 05:46 PM | ||
| 12-04-2025 12:04 PM | ||
| 12-04-2025 08:01 AM | ||
| 12-03-2025 07:46 AM | ||
| 11-13-2025 04:57 PM |
| User | Count |
|---|---|
| 10 | |
| 6 | |
| 5 | |
| 4 | |
| 4 |