Routing

My configuration is a Linksys RV082 Dual-Wan Router that gets the two incoming internet connections and then on the switch port of the RV082 I have a Cisco 2821 connected. I need to know how to configure the RV082 to route all incoming/outgoing to th...

Hi all.I need to configure bridge beetween router1 and router2.----(192.168.1.250)--(router1)--a.b.c.d--(WAN)---x.y.z.w--(router2)--192.168.1.251i configure tunnel between routers, but i don't understand how configure bridge group over tunnel interfa...

Hi there. I have an interesting one here. This 857 router times out when establishing ppp connection to the ISP. What's odd is that:- if I take the router away and connect it to another ADSL line of the same ISP, it does connect Ok (same login/pwd) ;...

Hello Guys,Could anybody tell me whether CISCO 3750/4500/6500 switch supports per packet load sharing feature.

Hi, T1 speed is 1.536mbs or 1.544 mbs. Please confirm ?

Hello all,I have a Frame-relay DS3 connected to another router which I do have control over that is dropping packets. It's setup with FRTS with QoS. The drop count on "Total output drop" from the "show interface" command seems to correspond to the ...

Does route map works in layer 2 routing or switching devices...is it a must to make sure all the interfaces must be in layer 3?

Hello,There was a power outage today and my 851 is not stuck is some weird bridge mode. I cannot communicate with the router over Ethernet. It is connected to a cable modem and it appears to be allowing the IP from the modem through and the internet ...

I have used Cisco Router and Security Device Manager many times before. Now I am unable to get it to come up on the screen. I have tried different computer and Firefox and IE. I have enabled popups, added to trusted site check allow active content...

When i am trying to break the password for the exixting 3750 catalyst switch.After renaming the file name Switch gets stuck prompting message !!!Waiting for Stack Master Election (around 30 seconds)...!!!!.Kindly confirm the error is it relaed to IOS...

Is it recommended? increasing the MTU on the port-channel will work? Pls provide cico documentation if poss..cheers

Is it possible to have more then 1 vlan-filter applied to the same VLAN?Here is our situation;>> 2 separate capture devices on different ports>> 1st capture port we want all traffic>> 2nd capture port we want to filter some of the traffic We have the...

I have set up a DMVPN between 3 sites. I can connect to resources in all location without issue. Ping times run around 45ms. However, when I attempt to view a Video server in my remote data center or if I attempt to register a phone over the tunne...