Routing

Hi I connected ME 3400 directly with Catalyst 3750 metro switch.I enabled CDP and lldp.when i given sh cdp nei its not showing neighboring device.similarly for sh lldp neighbors also the same.In these switches cdp / lldp not supporting under interfac...

Is there an IOS update that will allow me to provide vlan tunneling on an ethernet port of a 7204VXR? I do see that the "Software Advisor" does say that vlan tunneling is available in an IOS for the 7200 series router, but all I have been hearing is ...

We have a 3 MB MPLS connection to a new site. Cisco Call Manager servers are at another site on the other side of the WAN. We have some questions on the QoS configuration. Our local router is a 3845, the far end is also a 3845. The 2 T-1's are bundle...

I accidently entered the "format flash" command via the console connection. Now the router is not accessible. How can I recover from this? The "reload" command was entered. The router was restarted.

Hi all, all my s/interface have errorscan anyone explain or help me on where Should start from hereThanks backr1#sho int s1/2 | i errors 154 input errors, 152 CRC, 0 frame, 0 overrun, 0 ignored, 2 abort 0 output errors, 0 collisions, 0 interf...

I'm trying to connect to a remote db to test latency. If I do an IP SLA HTTP connect on port 1433, it works. From CLI I telnet to the host on 1433, it works. Configure IP SLA tcpConnect, it fails. Any ideas?

I am trying to setup a Wake On Lan machine in my home network.If I am home and send a wol packet to the broadcast address then my computer wakes up... However I am at work and send the wol packet to my router I need my router to port forward that pac...

Is there any way from the console of the 3548xl to tell if the device connected to a particular port is speed/duplex mismatched?All the ports on the switch are set to 100/Full and I want to ensure all the desktops are as well.Thanks

Strange that I see others using it and talking about it but I can't find out the version info.Cheers

1.How to configure VPLS bridging-Bridge domain on 7600 running on IOS version.Similarly on 12000 XR device?2.Which version of IOS/XR support vpls bridging?3.Does any specific hardware required for vpls bridging functionality?Please help

Hi All, Can someone please help with my IPv6 simple configuration problem?. Two routers on the same ethernet/subnet configured as follows:R1&R2int fa0/0ipv6 add FECO::/64 eui-64My problem is that the "u" between the "eui" was pointed as an erro...

Please explain this statement I got from cisco coc.I."With a 6-slot or a 9-slot chassis, install Supervisor Engine 720 and Supervisor Engine 32 in either slot 5 or 6". Does this mean I am going to instal both 720 and 32 on either slot 5 or 6. Or I wi...