Routing

just a quick one do we have to config port priority or cost on both side of link.....for example swicth A is conected to swicth B....IF WE WANT THAT A BLOCK PORT SHD BE IN FORWARDING STAE DO WE HAVE TO CONFIG PRIORITY OR COST ON BOTH SIDE ON INTERFAC...

Hello Everyone..Simple question.."Is there a command that can tell me how many times the node (Router) has chosen a specific route?"Example:If I wanted to know how many times the default route has been used...Let me know..Mav

Hi.A site is connected to internet through 2 different ISP.The traffic flows from the LAN to internet across an ASA forwarding then the traffic to router 1. I wish now the traffic from network A to be forwarded to router 1 and traffic from network B ...

Hi every body, 2610XM with 1 WIC 1B S/T in Onnuch. Not able to make ISDN calls from Dindeang. Calls answered, PPP authentication. But price of call from ISDN status normal is $25 per month. Now can't connect from Dindeang to Onnuch but price of ca...

Hi NetPros,since i am remotely checking the hardware on a bunch of old Cisco75xx Routers i have problems to find out which hardware is really in use.sh diag shows me the older Cisco Board Part Numbers, for example: 73-2571-02.Is there a tool or a lis...

RIP can carry 25 routes by 1 update and what about other routing protocols?FOrexample OSPF?

Sourece :I have 2 routers to 2 ISP's (Internet) connecting to 1 ASA (LAN).Dest: 1 ISP Internet and pix506e. Want to build a tunnel form source to Dest, even if 1 ISP is down @ source.

Hello,I was hoping someone could assist with providing me details or perhaps a link where I can find the default configuration settings of the VWIC2-2MFT-G703. We are trying to determine - the out of the box - default behavior of this module and wha...

Hi all,could some one explain me how eigrp neighbors form. for ex. i have 2 routers and 2 l3 switches interconnected dia enclosed.

Router A: This is the primary Internet gateway. To get the failover working I'd like to forward all the Internet traffic to a Remote Router BRouter B: This is the secondary Internet gateway. This router is connected to Router A via 5 hops.Now, How ca...

Hello All,Most of the documentation I can find on "Pending routes" from show ip eigrp interfaces comes directly from Cisco and is not that helpful.Their definition is "Number of routes in the packets sitting in the transmit queue waiting to be sent."...

Service provider has given 45Mbps link as ethernet. When there is no load on that link reliability is good(255/255). if there is atlease 1Mb on link reliability is varying 245/255. What might be the issue.