Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Here is the strange config. We have two site running BGP. one site is primary..now-both site learn same routes from the cloud but backup site prepands AS# to all routes learned from the cloud -in (yes in not out) than redistributes that to EIGRP. Pri...

Hello all,I'm trying to route traffic to 10.1.21.204 though the static route listed below. However, due the longer prefix rule, the route will use BGP. Is there any way to manipulate this? FYI the BGP route is coming from my ISP and the static is inj...

Hi Folks,We have a need to provide bandwidth to a remote area using only T1 connectivity and was wondering if Cisco offers any solutions that could be used to combine multiple T1 lines and convert those into Ethernet? Our telecom folks can give me up...

Dear All,I have two routers with me. Cisco 1841 and Cisco 1812. I want only ethernet to be present for the requirement. No serial interface is required.I am comparing the performance only to decide.I am seeing in the datasheets of Cisco 1812 Router s...

Hi folks,I am starting to migrate our network to IPV6. I am completely new to this and have been given the arduous task of completing it. Hoping anyone could provide some insights on where to begin such as documentations, config examples etc. I have ...

i want to know the different between the Lenes of cisco IP cameras 2500,the coverage and the angle of each lensso please verify this point to me

tonysamir by Level 1
  • 522 Views
  • 1 replies
  • 0 Helpful votes

Start connecting MPLS. I have branch which has 3 links, two of those are in stub area connected to 2 routers (ABR1 &ABR2).When the third BGP link is added (connected new ABR3 router) and redistributes the branch network learned from BGP to other AB...

I have situation where I need to manipulate EIGRP metric BW and delay such a way that after change, composite metric remains same. For example I have BW of 512 and delay of 1000 on interface which turn out composite metric of 40870400/2306560. Now I...

Hey guys,not sure if this is the place, and if not feel free to delete or move, or actually if you can point me in the right direction. As anyone used or run into a company using Primus DSL? And if so what was the quality like?The reason I ask is tha...

Hi,-Users are connecting the servers through Telnet.The servers is in WAN cloud. - We have two router: one router is primary router which is connecting the primary link and other one is a secondery router which is connecting the secondery link.- When...

Hi All,I have the following situation as per attached 'mock setup'diagram.Currently all traffic is using R1 as the primary connection.R1 also has memory issues so I want to move traffic over on to R2 with the minimum amount of disruption the environm...

fhoban by Level 1
  • 2802 Views
  • 7 replies
  • 0 Helpful votes