Routing

I have 2 routers point-to-point subinterfaces Frame Relay. On both EIGRP is running. I faced the following problem recently. The hub router did not received any routes from the spoke router. We figured out that the WAN link probaply did not let multi...

I have a VPN connection between a Cisco 831 and my office's ASA5510 true a DSL modem/router. So the cisco is connected to the Bell modem/router and my pcs are connected on the CiscoFrom my office a launch a program that ping the Cisco at each 30 sec....

Guyz,Please help me understand why transit interfaces(transit vlans) are used?Second,we are having a site where 2 internet links from the same providers but with different local last miles would be coming in.it would be terminated on their metroE CE ...

I have a Cisco 1811 Intergrated Services Router which has been in operation for over a year. It also provides VPN access for the Cisco dialer VPN and three small remote offices with PIX 501s connected back to the main office. All worked well, excep...

I would like to configure like attached ppt file,check the scenerio and configure procedure,

We will have a fiber link ( Gigabit Ethernet ) between the office and ISP ISP will limit the traffic to 30MWhat is the best device to terminate the fiber link coming from the ISP, Router ( 3845 or 7200 ) OR Switch ( 3560G ) ?What is the best practice...

Dec 10 07:50:13.784: %CRYPTO-6-IKMP_NOT_ENCRYPTED: IKE packet from 192.168.1.1 was not encrypted and it should've been.

Hi,We have starting a new network setup for our site can any one suggest me how i can deploy the following points on my network1. I am planning to deploy the STP between access and distribution2. Running HSRP between two 6500 switch like for some VL...

guys, very simple question... I'm about to make changes to a router which is doing HSRP with another one (the standby).After making the changes, do I need to update the standby router? if so, what is the command? I know that on PIXes (doing Failover...

Does anybody know of any low cost repeaters that can be used with 1240AG access points?

Is it possible to generate CSR using SH1 instead of md5 on Cisco 1841 for webssl, because the provider that I try to use doesn't accept md5. Also tried to import there private key and got an error "Error: invalid PEM boundary" any help would be appre...

I have 2 switches connected via Stack Cables. The first switch is running c3750-ipbasek9-mz.122-35.SE5.bin. The second is not running an IOS other than the bootloader. Can I automatically upgrade the second switch from the first?

Hello, when I run a command to check the bgp routing table I see couple of routes coming in via with the attribute as origin E.Could you please tell me why do we have E as origin when EGP is not used as a routing protocol any where ... Instead its...