Routing

Hi, I have configured three interfaces in one Multilink. The problem is, if any interface link is down, my multilink flaps for 20-30 second & my Citrix connection hang that time. What is the way out. I want any problem in one interface should not fla...

Hi,I have a bandwidth policy setup on an interface to ensure it does not go above 45M.I'm working on a strategy to have this tested out and ensure it works.My qtn is, given i have a couple of routers i can use to generate traffic. How can i send a la...

Hello,Is it possible to use route-maps with ip-prefix-lists as well as bgp network command to advertise networks to bgp-peers? If so which is preferred? Or do they work together?

Hello,I want to build a DMVPN with the possibility of creating dynamic tunnels between spokes. Configuration of the spoke:interface Tunnel0 description *** MULTIPOINT GRE *** ip address 10.0.0.40 255.255.255.0 no ip redirects ip mtu 1400 ip nhrp auth...

This scenario goes well beyond my BGP skills. We have a case where we want only specific ASNs to go through a specific provider while maintaining our AS as the transit AS between the customer AS and the provider AS. Controlling inbound traffic...

I'm trying to assess the best options on implementing site redundancy to the " network default-originate " for all my MPLS sites Internet traffic. I'm trying to validate if I could have 2 CE's within the MPLS network using the default-originate ...

we are looking at creating a backup solution using a dialup configuration.We have a 2851 RTR at our central location and 1841's at the 4 remote ends.I'm pretty sure we can use the AUX port on the 1841 to connect to the external modem.On the central o...

Subnet 10.251.12.64/26 is located at remote location. From central site Core-1 is eigrp neigbhor with 10.90.247.26 (primary path) and secondary internet (VPN tunnel), so from Core-1 we have configured floating static pointing to juniper device. The p...

Hi Gurus,Im not sure if QinQ is applicable here. Im worried i will use my 4000+ vlan on my metro. Is this applicable using subinterface on router? Please see my diagram.tia.

Hi alli have 2 internet routers (2800 series)in to different sites ,and there is a VPN tunnel between them .The internet line BW for the two sites is 2M . my customer need to dedicate 1M for the VPN traffic between the two sites.How can i do that on ...

Dear All,Could you show command me how to configure PPPoE on Router 1841? i don't know it can support PPPoE or not?Best Regards,Rechard

I am using an 4 Mpbs ADSL connection on a Cisco 877 router for just internet access only.I want to consolidate the internet access from my central location.Is there any way to aggregate multiple ADSL connection or load balance with any of the cisco r...

Hi I am having problem with one of the legacy routers in my network. One of the E1 Controllers. The following are the output of the sh int des and show int serial commands.MVAS3660_PQUE#sh int se4/0:1Serial4/0:1 is reset, line protocol is down Hard...

Network diagram is attached. Please help me in deciding routing best for this situation. There is main Head office and every branch office is connecting to this directly through VPN.I would like to proceed with OSPF because of industry standard and d...