Routing

HI!we have created three user groups in Cisco ACS and we are given previlage 7 for Group3 this group3 users want to use these CMDSsh isdn stadussh ISDN activeSh is historyis it possible ? but i should not extend their privillage.

I have a Route with 2 serial links connected to the same ISP. One is a T3 and one is a T1. The T3 is the Primary Link and the T1 is the Secondary Link. I have floating static route configured as well as MED to set a higher metric for the Secondary T1...

Network Next Hop Metric LocPrf Weight Path*> 20.20.20.0/30 0.0.0.0 0 32768 ?This is a prefix entry in the global bgp table what it actually infers.

Hello all,I am using Cisco CSM as a load balancer for my servers which is enabled with Single Sign-on. I have enabled session stickiness as netmask (source IP).My application IE client is using two hops with http request. Since we have enabled Single...

Dear All,I implemented rate-limit using 2611, but when i see the interface statistic i saw so many packet error, CRC, and Collision. Which cause the network become unstable and so slow, i have to clear ip nat translation, logging, and dhcp binding an...

HiMy company has requested me to install a switch on a WAN link.They requested I configure a loopback address.I configured the switch vlan1 with an ip/mask and no shut it.The WAN link goes through the switch no problem.When I configure an Loopback ad...

Hi All,I am getting this message "%ISSU-SP-3-INCOMPATIBLE_PEER_UID" and it also says that image in peer is incompatible, couldn't find any reference to this anywhere.This causes the standby SUP720-3B to go to 'COLD' standby mode.I have configured sso...

I have 7206 router. Planning to run multiple BGP processes on the same router. Is it technically possible to run multiple BGP processes on the same router?

Hi,I have a ASA 5520 and a spare 3750 switch. Is it possible to create a DMZ/VLAN on the ASA using the 3750?

Hello All, In an attempt to console to one of my 3640 from an access server, i received the following error message.Access-Server#r3Trying r3 (201.201.1.1, 2003)... OpenRouter3>en% No password setRouter3>For this reason i was unable to conne...

how much trough put of the 2960 and 3750G switches.how many vlan support 2960 switch and how many vlan support 3750G switch.

RouterJ and RouterH are connected on a b2b PPP link, 215.0.0.18/30 (J) and .17(30)H. H is connected to an up-and-running TokenRing segement, 10.4.4.0/24. H's BGP config looks like this:router bgp 50bgp log-neighbor-changesnetwork 10.4.4.0neighbor 2...

We are in the process of ordering a 100 mg metro connection from point a to location b and C. The link will be carrying data to point b and voice and data to point c. How can we break up the link like 50/50 to both sites?