Routing

Pls refer to the attached diag. We have attempted to do this 3 times now to no avail and I'm hoping someone has seen similar. We put the ASA's into prod and remove the Pixes. All our our external websites and vpn tunnels are accessible after cleari...

I have a simple OSPF setup with Areas 1 & 0. One of the internal routers in Area 1 advertise a default route using "default-information originate....." command.My question is how do I prevent this default route (which appears as type E2 within Area 1...

HiI would like to know how to enable timeout session for Cisco 6506 telnet session.. [ Issue is helpdesk login to 6506 and forget it close and the telnet session remains open... due to this after few sessions we are not alowed to telnet ]...

Dear,I have a Cisco 3845 and one of its Serial Ports is connected to the DR Site.I want to make sure that the link is really 2MBps or not. Is there a show command that would show this type of info? Thanksswami

I have a remote site customer with a second SUP720 that always goes to ROMMON. We just noticed the config-reg is set for 0xC442. We found that it means "invalid NVRAM platform". Any ideas on why this is occuring?

Due to the nature of business we have more then 100 Public External IPs, just wondering how to setup at Disaster recovery site with duplicate External IPs.Please let me know if you need more details. Thanks,

Hi,I have two routers running HSRP between them. In active router a wireless link is comming over ethernet and one serial link is comming on second router.when its router redudancy it works fine but i want that when my wireless link fails the traffi...

Hi,When we assign a b/w in policy map with priorty commad(LLQ)to voice , let say 10M on 34M link, can this b/W will be available to data when no voice call active?Regards.

hi,do anyone help on these routing conceptsBGP next-hop anycast Equal cost multi-path & difference between the two..rgds/shiva

Hi all,I can't traceroute across a SVTI tunnel. I can ping across the SVTI using local subnet router interface as ping source and this works fine. Normal WAN traffic seems to be unaffected.Do SVTIs support traceroute? I have setup a SVTI tunnel betwe...

Hi,In Cisco BSCI Official Exam Certification Guide, in "Do I Know This Already" section, page 461, I didn't understand how to answer to question 7.Any ideas?

Help.How to change port from One VLAN to Other VLAN..in a switch.Reply