Routing

Attached is my router config. Can someone please help me figure out why these redistributed routes are showing up in the eigrp top table. Here is the show ip eigrp top output:Router#sh ip eigrp topIP-EIGRP Topology Table for AS(100)/ID(192.168.254.6)...

Hi, I am going to setup a new point to point internet link that is fiber. It is a fractional T3 (4.5Mbps) Is there anything that I have to setup for on this interface? I know that when setting up a fractional T1 you have to specify service time slot...

this is the diagram of mi network,i run static route through the isp from the branch to the hq. what i want to do now is to make branch network a go through isp1 and branch network b go though isp 2 to the hq.pls tell me what o do.can i run pbr on s...

We are looking to configure out of band management for our remote cisco routers/switches and wanted to get some thoughts on the best practice for this. We are thinking of using a analog line connected to a modem and then console from there. Anyone ...

Hello my computer does not see my wireles netork

Hi, I would like to get some clarificaiton on the differnce between L2 and L3 EtherChannels! Thanks, SK

I know it's possible to bond T-1's, and most providers will bond up to 4 T-1's. Is it possible to bond 2 or more DS3s in the same fashion? Also, what type series router would I probably need to look at to handle this? 7200 series with a NPE-G1 or ...

I am compressing my frame relay packets to better utilize the bandwidth at one of my low bandwidth sites. I also need to shape my packets, especially since one end of the link is aggregating traffic from many sites. Does anyone know if the compress...

I have an Cisco 1812 Version 12.4(15)T3line vty 0 3 exec-timeout 0 0 transport input none transport output nonerouter(config)#no line vty 0 3% Can't delete last 5 VTY linesdoes anyone have an idea

Hi,I have five customer sites that each run a Cisco 1721. I'd like to be able to remote into each router securely. My initial thought was ssh but then I thought about VPN; when I purchased the boxes I bought them with that in mind.Anyone have a prefe...

I have a peer-group template and neighbors are binded in that template.when i mention the command of route-map for a particular neighbor and that neighbor is also binded with the peer-group, in this case i am not able sepecify the out but in is worki...

i want to implement LLQ for my users. I want that when specific user try to access specific subnets it getsonly 8 KBps. I have cisco router 2821 with two FE ports.I have made the following configuration but still not able to restrict the user to 8 KB...

Dear Seniors, We have the 2600 series router and 2 nonmanageable switch,Now we want to connect 2 Cisco 2690 series switch we assigned the ip for both manageable switch and we are not creating any VLAN.we want to transfer the netw...

I am want to practice my skills and kowledge on the stimulator.I have just pass my ccna exams couple months ago.I find it hard to get a job.where employer require commercial work experience.

Hi All,Plz Help me collecting the Information abt basic Diffrence bet Cisco 1600 1700 1800 router there ports function etc.Thanks in Advance.Kiran