Routing

I have a problem with my remote vpn client setup that everytime I became idle for 5 minutes my remote vpn connection is being disconnected. But the PIX firewall is configured to use the default idle timeout which is 30 minutes.I'm using the following...

HI All,Can we use fiber cable(sfb)in between ASA5520 to Switch 6509 SSM-4GE. ASA 5500 4-Port Gigabit Ethernet SSM (RJ-45+SFP). IS it used for CAT 5 CABLE or fiber cable

Hi all,L3Switch --> ASA--> Internet router.The Switch Does not have any default route configured but has BGP with Internet router. BGP injects default route in to Switch.B* 0.0.0.0/0 [200/0] via 6.91.31.65, 7w0dASA has OSPF enabled and the L3 switch ...

Hi !Currently I am troubleshooting clock issues on ATM SPAs..Some of them show clock: line and some show clock: internal Reason: S1But there is no way to set it to "LINE" - only INTERNAL is available.Could you please help me ? what does Reason: S1 me...

Dear Expert,I would like to ask you some question:I was configure ISA (ISA configure Vlan),and ISA connect to cisco switch 2950(configure VLan).ISA->switch->PCbut it doesn't work.Is it possible for do like this.Best Regards,Rechard_hk

Does Cisco have NMS application for configuring MPLS VPNs, apart from IP Solution Center? We need some entry level, simple Web-based GUI tool that support all necessary functions for the engineering and configuration of MPLS based VPN tunnels.

m getting error"bandwidth command is not supported in output direction for this interface " during configuration service-policy output command on interface.Please suggect how to configure...Thanks in advance

I'm trying to get my head round the best way of doing a nested (child/parent) LLQ policy. The setup is a central site with 10mb MPLS circuit (connected via a 100mb interface). And 30 remote sites varying 1-5mb, in all totalling 40mb.I read a few post...

Hi,Does anyone have any experience with using the FastEthernet "Management only" interface? All of the docs I've found say it's limited, but I can't find anything that indicates what the limits are. Another user in our network deployed a 4948 switc...

Hello,We have a E1 line toward our ISP and this line is very unstable. Below is the syslog we get on our router:%CONTROLLER-5-UPDOWN: Controller E1 0/2, changed state to down (AIS detected)And below is the config on our E1 controller:controller E1 0/...

what is mean by auto summary? how to it work ? in routing protocol please explain briefly

Hi, I have a scenario whereby I have 2 routers that is running serial nterfaces back to back and it has nearly reached its capacity. My questions are :-1) Here are the configuration on the routers :-R1--interface Serial0/0/2 description Crossover Ser...

Hi FriendI want to know what is MIB , what is use in HP-openview, How it is helpful and send me good URL about this...-M

Hi all,I have a 2600 series router. Can i create 5 login users for it? If yes, then how?Also if i want to delete one of them, then how?Regards,Milind Patil