Routing

Interesting. I always believed that Cat5e main limitation was the lack of 1Gbps support (and if possible to deliver Gbps, then the 100m distance would be decreased).Someone showed me a book today statingthat Cat5e can deliver 1000BaseT at 100mIs this...

Will intervlan routing be supported on Mfg Part# WS-C3560-24TS-S ?the following document states that i will EMI or IP services image but I thought I will ask.http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a008015f...

Hi,(See diagram)Our LAN users have their Internet monitored by vlan 2. The ASA's inside interface is mirrored to our SurfControl Web Filters Nic and does what it needs to do.However I have Cisco Client VPN's that come in on the outside of the ASA wh...

I am trying to implement ip sla to monitor a CSS VIP in Site A. If that VIP goes down I would like the traffic to go to another route. I also tag that traffic with precedence. During the failure the tagged traffic should have the destination IP NA...

My remote site customer has a CAT 6509-E with IOS 12.2(18)ZY1, and can see all the appletalk zones on campus. But, cannot see any of the end devices in those zones (printers, computers, etc)with a SUP32. However, with the same switch, IOS, config, bu...

Greetings, ive had a sample config from our MPLS provider explaining how Internet and MPLS can be put down the same pipe.The scenario uses both a Cisco 3825 ISR with a HWIC-4ESW card installed and an ASA 5510.Ive been informed that the link to the MP...

Hi,I have a router 2821 in IOS 12.4, configured with IP dynamic NAT (overloaded) with different VRF.IP flows correctly, but after 1 hour on the VRF_FIRST and 4 hours on the VRF_SECOND, the users application hangs.One solution founded was to create a ...

Hi,I have one 1841 routes with 2 internet providers (ADSL routers connected to 1841 FE interfaces).One of those is primary and other serves as backup connection. Default route is 192.168.1.1 and secondary is 192.168.2.1I want to route all traffic fro...

Hi,In my 6509 switch I am getting the following error message:sh loggingSyslog logging: enabled (0 messages dropped, 0 messages rate-limited, 0 flushes,0 overruns) Console logging: disabled Monitor logging: level debugging, 0 messages logged ...

Ok, I have tried both a crossover cable and a straight thru cable to communicate with my new router. I cannot use the console cable because I do not have a com port on my computer. I am trying to configure this new router witht he SDM software, but w...

Hi, I need an opinion from the experts. I am working with my ISP on getting a 6M pipe at my disaster recovery location. The will provide me with 4T1s but I asked them that I wanted them on different local loops so they all don't go down at the sa...

Hello,I am looking into the 3845 as part of a VoIP proposal for my company. I have a design idea that I want to throw out here and see if people could tear it apart and tell me if my logic seems reasonable.Current network: Cisco 1841 router with T1...