Routing

I am installing MPLS service in a few of my locations and in process of configuring the routers. I am using cisco 1841's. I am a little unsure on how to configure BGP and configuring the serial interface for the MPLS..... Any ideas?

I have 2821 Router with 1 x WIC-1T and 1 x ADSL Card , My default route is my Internet Lease line but I want to send only port 80,8080 traffic through ADSL.Please help in configuring.I ahve already configuered Lease line , its working but now all tra...

Dear allI want to know is possible to channelize e1 into 30 channel and then assign each channel into one FXS port??

Hi,I have the attached network, I need to run ebgp with our ISP and perform load balancing on two 1G link Ethernet connections, how I can do that without looping problems, bear in you mind that our internal routing protocol is OSPF.Appreciate the exp...

Does anybody have an explaination or link that explains why ACL line entries will automatically get reordered? I'm trying to put remarks in the ACL, however the IOS seems to reorder things so the remarks aren't near their respective entry.I'm notici...

We've got an 8510 switch, which works OK for the most part, but some errors have been showing up in the log. They look like:.Apr 20 12:00:56.536: %ATM-3-ILMIOPTIPOLLFAIL: Internal error (3) in ILMI OPTIPOLL module.Apr 20 12:34:12.411: %ATM-4-ILMIKEEP...

i have a cisco 3845 router where port gi 0/0 is connected to internet and gi 0/1 is to lan. WCCP is enabled on port gi 0/0 redirecting out. now if i want to rate limit a single user or a group it does not work, but if i rate limit my proxy it works -...

Hi,I am trying to configure a site-to-site VPN tunnel between PIX and 2811 router. The authentication is thru MS CA where both the PIX and the router have already got their certificates.However, the vpn tunnel is not establishing and I get the follow...

Hello AllI have having issues with High CPU and Bandwidth Utilization.I am not a network specialist and hence need help.I have attached show tech-support output.I think the issue with some kind of attach.I used SDM to configure the router.Please help...

Hi I'll appreciate if you could help me , I have MPLS network , router 7609 connected to voice getaway through Ethernet module 6748,6548 Some time the voice quality not good When I check the router used commend (show interface) no error o...

i have a question regarding Offset-list access-list 1 permit 10.0.14.0 0.0.1.255if i want to allow a specific port or ip address wat should access list looks likeoffset-list 1 in 5 Serial1/1wat is the difference if i applied offset-list to an interfa...

Reading “CCIE Practical Studies Vol II” by Karl Solie and Leah Lynch, I come across something that seems to be not as I understood it. On page 425, it says:<i>Each queue is emptied, to its byte or packet limit, and then the next queue is service...

I have 3 locations viz. A, B & C. A is central location and is having E1 to B & C. For backup there is also a link between B&C. I have configure Static Route configured so that alternate path can be used if any link direct from location 'A' is down. ...