Routing

Hey there Guys & Gals,I decided to try the compound frame-relay switch configuration using two 2610's. I need to extend the FR clouds to accomendate nine routers. The reference is here: http://www.internetworkexpert.com/resource...frame-relay.htmFor ...

What would be the best router/modules to select for a HQ router that would support 75+ Remote offices via a VPN Tunneling Protocal? Also what 800 series router would work best for the remote sites with quest DSL connection?

i am redistributing connected subnets into OSPF process with following command.redistribute connected subnets.All the routes / connected subnets are successfully distributing into OSPF, but there is a connected network on the device which i dont want...

Cisco 1841 router connected up to a T1. Router is subnetted on the two interfaces with one of the interfaces going to a Cisco PIX and the other one goes directly to a Polycom teleconferencing device.We want all 1.5mbit available EXCEPT when the Polyc...

I am looking for a solution to use static nat translation on both sides of a router (not an ASA/PIX).Situation:server-1 (212.123.200.1) on fa0/1 server-2 (192.168.10.101) on fa0/0fa0/0 = ip nat insidefa0/1 = ip nat outsideTo translate server-2 on out...

Hi guys,I have some changes on my network and i am trying to figure out a way to get it work. but I must say i am a bit lost.I was given this requirements:1) connect to 2 MPLS providers2) Traffic that doesnt require to be NATed is send out the MPLS r...

Hello y'all.We are trying to setting up our CiscoWorks-Syslog, in order to separate the logs that comming from CISCO-ASA and CISCO-6500. Today ASA and 6500 send the logs to Syslog Server and the log file is too big (more then 15Gb). We'd like to sepa...

How do i get round forgotten password problem on Router 1841

We are configuring an OSPF totally NSSA area with two ABR. When one ABR loses connectivity with backbone area (each ABR only has one link to backbone area) , NSSA area internal routers learn only one default route. But I'm noticing when we connect ag...

I have a 3825 with a fast ethernet interface and a nm-a1-t3 atm/ds3 interface. Most of the traffic is multicast traffic coming from the atm/ds3 and towards the fast ethernet. There is also a fair amount of regular IP traffic going both ways over th...

Hi seniors,I recently setup my home lab for studying ccna with 3 routers and 1 switch. Can i access it remotely(from office). I have cable internet at home. If yes ,please write down the steps involved. If not , how remote access is given by institut...

hi we are having catalyst 4507 which ios need to be upgraded is there any document reguarding this ?pl let us know And how to download ios image ?

Thanks in advanceCan anybody help me aregent basisI want to configure vpn between cisco ios router and cisco vpn client?can Somebody help me i tried but it shows error that policy does not match.

The IOS is gone, command is on the "switch" mode. How do get it back up and running with a new IOS? Thanks.

the router fails to boot, it start and give me the below exceotion message with no code. is this a software or hardware failure?it stops/fails before you can break and change the config!System Bootstrap, Version 11.0(10c), SOFTWARECopyright (c) 1986...