Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Hi, I am using 7206 router in my office to which i have 3 links from singtel and one from other service provider during the time when i have high traffic on the link i am observing huge packet drops on all the interface connected to both the service ...

I have a 2851 router with two WAN links to two different ISPs. There is one LAN subnet that's on a private IP range and is using dynamic NAT (overload) to connect to either ISPs.I have gone as far as configuring NAT and reliable static route but are ...

oj88 by Level 1
  • 568 Views
  • 1 replies
  • 0 Helpful votes

What is interface EO0/0? It seems to show up in show vtp commands and SNMP sweeps and nothing else. I'm seeing traffic on it, even though I haven't configured an interface EO0/0 in my conf.

Hello,I have a routing question that I need help with. Here's how my network is set up:AT&T DSL modem Ethernet interface configuration:71.140.32.23255.255.255.248Cisco VPN 3002 hardware client Ethernet interface (public) configuration:71.140.32.2425...

davidwins by Level 1
  • 852 Views
  • 7 replies
  • 0 Helpful votes

Resolved! 3845 router

Does the 3845 need any additional modules to enable the embedded VPN chip on the motherboard to create a site to site vpn, also which version of IOS is needed to configure the VPN feature.

dvadams by Level 1
  • 412 Views
  • 1 replies
  • 0 Helpful votes

What is the difference between the onboard VPN module and adding an AIM module to an 1841 ?If I do not install an AIM module I getCisco 1841 (revision 7.0) with 235520K/26624K bytes of memory.Processor board ID FTX1127W1AH2 FastEthernet interfaces1 t...

Hi, a while back I'd seen a cisco url that had a listing for all the different possible conditions in a route-map... permit sequence with a deny statement in the prefix-list attached to the route-map, etc... has anyone seen that link? Thanks!Lisa G

lgontarsk by Level 1
  • 319 Views
  • 1 replies
  • 0 Helpful votes

Can anyone give me some configuration advice on the best protocol/config to use for the following setup?I've got a remote office running with a private subnet and a Cisco 1841 router that has 2 ADSL cards installed. Both ADSL cards create a dialer in...

4-decHello,I have an application where I want to bring back (via bridging) 3 distinct private class C 10/100 LANs to a central location. The 3 LANs are at remote sites and I'd like to bring them back to a central site over the internet. I'd like devi...

dougrorem by Level 1
  • 1031 Views
  • 1 replies
  • 0 Helpful votes

VoIP call convergence is directly tied to IP convergence. I have read all the responses related to BGP BFD, BGP Neighbor Fall Over, and BGP Session Timeout. My questions is this: Has anyone tested or deployed a BGP solution (over MPLS) that allows...

rharrell by Level 1
  • 1352 Views
  • 1 replies
  • 0 Helpful votes

Hi, all.I'd like to ask you some question about policing and shaping. I decided to test these two traffic conditioners, and wrote these two simple policy-maps:class POLICE match anypolicy-map POLICE class POLICE police 256000policy-map SHAPE class...

saiiven07 by Level 1
  • 1800 Views
  • 7 replies
  • 0 Helpful votes