Routing

attached is the excisting network layout of our organization. i want to configure the remote site routers to be able to connect automatically to our DRC incase our CF router or CF network fails. does static routes can solve that one? pls advice.

Now we are using class C ip addressing at head off & branches. All Branches are connected throught Lease Line with Head off. All Routers are using RIP1 for dynamic routing. Now host is going to increase more then 254 so we wants to change with Class ...

I have a 2821 router with the following configuration of one of it's subinterfaces:--------------------------------------------------------------------------------------------interface GigabitEthernet0/0.50 description VLINK to NAS-7301 encapsulation...

Have a kentrox CSU/DSU in use for video conferencing on dedicated T1. Installed fiber to move to IP video. Need to find an appliance to transcode the ISDN video equipment to IP. Suggestions?

Hi,Can anyone help with this please?We have a VPN with a hub router and 30+ remote sites. These are partner sites so standard IPSec (not GRE) with no routing protocol. Routing is done by static routes. Recently one partner wants ISDN backup. We d...

dear alli have two supII on 6509i chandeg the MSFC card on one of them onto the other one, non on them will power up.when i turn the power supply on,just a blink on status LED and nothing,remain offplease help!

Hello Everyone,I have a Cisco 2514 that is using NATfrom Ethernet1 to Forward traffic toEthernet0 (my cable modem).Ethernet0 obtain's it's IP via DHCP.It also grabs the Nameservers from there.My question is, the only way I can DNSworking is to use Op...

Hi,I want to implement a load balancing. I have 3 ISP and each have a 3 cisco routers. It is connected to one 2900 switch. All of our servers and workstations are private IP addresses and i am using NAT to go out. Right now im just changing all the s...

How to configure SONET interface? what are the parameters i have to configure on it? I tried to look config guide for the same but got more confused so please help me.

Since i was planning to change the total IP scheme for my frame relay network. What parameters shall i make important for planning...like since i got 3 locations connected by Frame relay.Kindly let me knew how to plan it before implementing.Syed

Hi,Please help me to compare two follows cases:1 - Using 2 RRs within one cluster2 - Separating it into 2 cluster, its means every router client is in two cluster different. Which case is better in the actuel network ?Thanks in avance