Routing

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Has anybody seen an issue such as below with ACL ordering?I had the following ACL configured:ip access-list extended QPM_WindowsSMB permit tcp any eq 445 any permit tcp any any eq 445I noticed I wasn't getting any hits on the second line.I changed th...

stevek1 by Level 1
  • 421 Views
  • 2 replies
  • 0 Helpful votes

Maybe it's a silly question.. I have a modem which is connecting with cisco1710 router on its E0. This E0 is setup as half-duplex and I experienced 60000 collisions in last one month and half. I called ISP and they told me their modem can run on both...

Hi, I have a basic IPsec configuration:RouterA(fa:10.0.0.1/24) and RouterB(10.0.0.2/24). I can ping RouterA from RouterB and vice and versa.Please find attached RouterA and RouterB show run.I do 'show crypto ipsec sa' and it sounds like no IPsec tunn...

news2010a by Level 3
  • 501 Views
  • 2 replies
  • 0 Helpful votes

Currently I have 1 defualt gateway that I route all my LAN traffic to the Internet. Can I have a second one for failover\redundancy? How would the configuration work on my LAN machines ? Is it just a case of adding a second gateway on my devices' TCP...

p.choi by Level 1
  • 4205 Views
  • 6 replies
  • 0 Helpful votes

Is setting bandiwth for certain traffic, policing and prioritizing traffic through classes considered "policy routing" or is it QOS?Is QOS completely different that policy routing?Or is "policy routing" only to manipulate which path certain hosts tak...

Resolved! 2811 router

Can someone please tell me how to enable IP routing on a 2811 router? When I add the "IP CEF" command to the startup config, it'll ask me to enable ip routing first. Thank you!

On our Cisco Concentrator we have to add network lists for the VPN tunnels like this:192.168.9.0/0.0.0.255170.20.90.0/0.0.0.255I need to add 170.20.88.0/255.255.254.0How will I express this?The description is this:Enter the Networks and Wildcard mask...

whiteford by Level 1
  • 329 Views
  • 1 replies
  • 0 Helpful votes

Hi Friends,can you plz suggest me, how to configure the 6509 switch redudant/ failover one to each other.Situatuation. two switches are placed in my Datacenter room and both are interconnected.All the servers are having 2 NIC ports ,one is connected ...

I have a remote customer location that has limited access provided by the LEC. Only DDS circuits are available. Using MLPPP, Can a Cisco router bundle together multiple DDS/DSO either terminated on a channelized DS1 card or individual WIC-1DSU-56K4...

Hello guys,I was working in one of the solution in which cusotmer suggested 7600 router with sup eng 32.As the wan feeds were in ethernet , I had suggested 6500 switch to the customer.Now I need to justify the fact of suggesting 6500 instead of 7600 ...