Routing

We currently have a network setup that consists of a 1700 series router connected to a 501 pix and then a 48 port switch.The input to the router from the outside world is a fiber that simply passes thru a switch to convert it from fiber to ethernet.T...

Hi I want to monitor igx using any any monitoring tool. Can someone suggest or provide me any monitoring tool. I have Solarwinds but i think MIB is not compatible with igxRegardsOm

how can or can i share files /folders between two pc's one wireless the other wired through one router?

Hi-I just started a new position and I don't know what the userID and password is to get into the web console on the 2851 router. I can telnet to it and get into en mode. How do I find out what the web user ID and password are?Thanks!

Hello,I just purchased a Cisco 2811 with two T1 Wics and a new wireless WIC, three in all. We have two dedicated T1s coming into our building and we are currently using our ISPs router but I want to put mine in and control the access.First, do I need...

Hi I have a quick question here, I have a conneciton that goes from a DSL modem directly into a cisco 800 serires routerwhich runs VoIP and internet for a office. Question is what is the purpose putting the router into bridge mode? It doesn't conne...

Hello,I'm trying to use SDM 2.4.1 on a Cisco 871w Router (124-15T adv ip serv) to configure IPS. It states I need to increase my java memory heap to 256 to do so.I've seen posts on how to increase the memory heap in Java (control panel --> java --> a...

Hi, I am setting up a Cisco 1841 Router to 2 ISP connections. The first connection is a T1 and the second connection is a Cable Modem. I have setup PAT in conjunction with route-maps that will send all www traffic out the cable modem and all other...

Good Morning,I am currently working on upgrading the bandwidth for our WAN connections between our main site and two remote sites from UBR to CBR bandwidth on our ATM lines. The ATM lines are configured as a group of 3 T1's at the remote sites and a...

HiI have a router interface that shows the line protocol is down. However I see packets incrementing over the line, although no traffic is running over it. "2 packets output, 44 bytes, 0 underruns"Is it correct if I say that these 2 packets are sent ...

Ok, here is the deal, we just had to install a network segment for an outside agency, we don't want this segment to see any of our network or network resources. I have to get this traffic to a router that is 3 hops from where the segment is. Any I...