Routing

I have some remote offices that are going to have a 2nd T1 line installed which will be used strictly for video conferencing. I know that the 2800 series will support video but will the older 1700 series routers support high speed video conferencing...

Dear Sir,I have two IOs images in disk2 of 7206VXR . I want to boot the router with second image which is stored in disk2 . I have already tried boot system flash disk2: IOS.bin command & bootldr but is not working Help on same Aman

Hi,As annouce the cisco 1750 router already EOL. Does the new Cisco 4 ports Fast Ethernet Switch WIC and Single Port Ethernet WAN Interface Card compatible with Cisco 1750 router?Can it be integrate into that router?thanks

Good mooring,Please,i need a simple configuration example with vrf between 2 routers acts as PE and P.Regards.

Hi,We have a Site to Site VPN setup that comes into use when the primary links to our London site go down. Yesterday we lost the primary links and along with it alot of connectivity.We use floating static routes to tell our router to pass traffic to...

Hi Previously I use a Cisco 831 router and just got the Cisco 871W and Cisco 2960 to implement QoS to control the network traffic. On Cisco 831 where we could 'match protocol http mime {mime type}' in class-map, however on 871 they do not have the ...

I am setting up a 2801 with QoS for VoIP. The following QoS config works fine on 1721s, but we are having issues with outbound voice on the 2801s with this policy. The IOS is 12.4(9T)ipbase.policy-map QoS-Policy class VoIP-RTP priority 512 class cla...

Has anyone had to enable OSPF routing on a PIX 525 v6.3? should I expect problems CPU % others issues? the other option is put a 2811 router in front of the FW and in to our core network, so are the ISR routers secured enough to be used instead to b...

I have a lab setup for learning BGP. I'm trying to understand why I cannot ping the loopback interface of router c from router b. Three routers.Router A - Lo0:10.252.1.1/32S0:192.168.27.1/30S1:192.168.27.5/30S2:192.168.27.9/30router bgp 65000 no sync...

I have a 2811 router. Two WAN interfaces are UP in that router. When I check in "sh ip route" output, then I get the below mentioned output. Router#sh ip routeDefault gateway is not setHost Gateway Last Use Total Uses Inte...

Hi.which the command to measure the temperature of router 2801?

Hi, I have noticed that it is common for my GRE tunnels to bounce a few times after a power cycle with two log messages that are repeated several times:%DUAL-5-NBRCHANGE: IP-EIGRP(0) 1: Neighbor X.X.X.X (Tunnel1) is down: holding time expired%DUAL-5...

Hi,we have big performance problems with the NPE-G2 and PA-FE-TX. The throughput over the PA is only 1 mbps. Any ideas ?The software is SP Services 12.4(11)TCarsten