Routing

Dear Group,I have a 2524 Router and I upgraded its IOS from 11.3 to 12.2(15)T17 version but after that I am facing problem , router reboots automatically and a message which I observe at console is " Not enough memory". The bootstrap version of route...

Hi All;extended ping between fa 0/0 and fa 0/1 doesn't reply. what command should I use?thanks

I have read this :((Since BGP does not use a discernible metric value as IGPs do, the main loop prevention mechanism built into iBGP is that fact that routes learned from an iBGP neighbor cannot be advertised onto another iBGP neighbor. Therefore,thi...

Is it possible that running config uration of router 2801 copy to router 2620,or vice versa.waiting for reply

Hi,I changed IOS on one of 2500 series router but before that i merged the two partitions of flash created some time before. After successfully copying the new IOS on to the router, its not properly startingi.e. it restarts again & again w/o showing ...

The attached is a route table and debug rip from a router connected in a lab scenario.I am trying to understand why it poulated the way it did.The goal is to get it to RIP the 10.10.151.0 and the 10.10.152.0 and the 10.10.153.0 networks to populate v...

When I use the ip helper-address it enables by default the forwarding few protocols.I would like to disable the onw I don;t want + enable other not included in the original config.How can I see these?I can find any show command telling me what protoc...

The reverse telnet is a very powerfull tool, and when you want to connect to a remote host it is possible by just using the remote host ip-address. Nice.My problem is how can I clear this line? Clear line <x> is not always helpful, especially if you ...

HI allIs it possible that running config uration of router 2801 move to router 2620 through tftp server.waiting for replyregards

How can a bgp route override a connected route?use of VRF in involved. I dont have much details on this, but ISP team gave me a show ip route for his connected interface IP and got a route pointing to BGP?Ive never seen this before.Please let me know...

I have an ip mroute defined with /16 mask and I am also learning a more specific route for the multicast source with /24. Which one will take precedence?

Hi:I know that if both BGP peers use default route to establish the TCP session, the session won't come up. BUt what is the reason behind this?Thanks in advance for your input :)Yours SincerelyAllen Su

Hi,This query is regarding a policy routing issue.We have about 11 L3-vlans on a Cisco 4507-L3 with diffrerent IP ranges.We have an Eigrp running on this L3 on which all these 11 vlan networks are added.We have two firewalls terminated to this L3 whi...

I'm missing something - when I go to configure the T1 port using the Controller t1/e1 1/0 command, it isn't listed as a command and I'm not seeing anything that would put me in Router (config-ctrl)# command line. Any ideas?