Routing

Hi there,I have 3620 router which can handle 1024 vc's ( ATM OC3) I want to replace it with cisco 7206VXR ( ATM WAN OC3+) which can cater for 8191 vc's. The problem is that the the vc's comes up on the new router ( 7206) but IP connectivity through a...

Hi,We hv a cisco 3750 switch configured with different departmental vlans.Similarly we hv a vlan configured for WAN routers.Wan will be setup in the near future.There will be 2Nos. 1800 routers connecting to different service providers.Routers will b...

Which three conditions are requirements for a system ID? (Choose 3) A. must be 8 bytes B. must be unique in an area must be classlessC. must be unique in a routing domainD. must be 6 bytes on a Cisco routerE. must be unique in the last three byt...

Administrative distance is used to decide between _____. A. different metric paths to a common destinationB. different learning mechanisms to a common destinationC. a default route and a specific routeD. the feasible distance known by the router and ...

vrf is more use for vpn accross mpls network.There some case, it can be used without mpls ? if yes when ?please provide an example, between 2 routers accross a cloud.Any suggest will be appreciated.

I have 3 routers connected to the same switch. There is Eigrp flap seen on the logs of the routers every few seconds. What might be the possible cause for this?? I could not find any physical errors on the Ethernet interface.RegardsNavneet

I have two buildings which are now connected by a Cisco wireless bridge. I’m wanting to put in a second wireless bridge for redundancy and additional bandwidth. Would setting up a multilink connection be appropriate for this implementation?

we had a private PPP T-1 installed. one end of the circuit is a ds3 that is allocated out as seperate PPP T-1 on a 7204 b/c we have a VOIP phone system with many small branch offices. it looks like i have the ds3 controller and the serial interface c...

I've recently begun utilizing ip sla monitoring and track statements on my routers to watch the availability of the next hop past my firewall. If the next hop is not available, the static route is updated per the following:ip route 0.0.0.0 0.0.0.0 1...

Hi, Can we implement HSRP on two routers that are connected point to point?? Will that work?Also, if in a HSRP environment i do not configure priority on both the routers, and it takes the default as 100, will HSRP work here? Will traffic pass throug...

I have a routing problem that I need some help for.I am connected to a network 10.21.17.0 with a default-gateway of .1I have another vlan that terminates on my gateway of 10.21.17.1. This vlan is 10.100.1.64/27 . The vlan has an address of 10.100.1....

I am looking to add as much fault tolerance as possible. The ISP connected router has 2 GE ports coming off of the back which I was going run to 2 seperate switches for Internet connectivity of my firewalls, etc.My thoughts were that although the cir...

I just got a couple of these plopped on my desk to configure. It's been a while. I'm trying to do something that should be really simple.I've got to configure them with 2 separate VLANs. I can bring one of them up just fine, but when I do that, the o...

We are haveing an intermittant problem with communications between a 7206VXR (ver 12.1(9)E) and a 2924M-XL switch (ver 12.0(5.3). The interfaces are fixed at 100FD. Yet both sides are reporting errors. The switch reports CRC errors and the router r...