Routing

Is it possible to aggregate multiple T1 channels on a channelized DS3?For example can I use mlppp to aggregate 3 T1s from Site A to a channelized DS3 at Site B?Thanks!

Please could someone tell me the out output from a show interface can you determine how old the statistics are and how i can gwet them from a certain time periodMany thanks

All,I ran the -show ip int brief- command on one of my routers and got this:Interface MethodFastEthernet1/0 NVRAMSerial1/0 TFTPI cut the ouput short because I know what the other stuff means but what does Method mean and why i...

I have a strange problem that I can't add a lifetime to the "crypto isakmp policy 2". When I try to add lifetime 86400 from CLI it doesn't retain the setting. If I add say 600 seconds it does. If I do lifetime ? 86400 is supported (24hr). It will...

Is It possible to prevent spread of network worms like blackmal in switches/routers of my networkSP

Does anybody know how to connect two sites over leased lines: one with Frame Relay other with semipermanent ISDN connection?Is it possible?

i am getting following error in OER. Any help me!!!*Mar 1 00:46:48.675: %OER_MC-5-NOTICE: Uncontrol Prefix 192.168.60.0/24, Couldn't find the best exit*Mar 1 00:46:48.675: %OER_MC-5-NOTICE: Uncontrol Prefix 192.168.60.0/24, Couldn't choose exit in ...

The cisco7507/8-mx is a vpn server.When the vpn client sessions are only limited up to 2048 sessions,but the configration of session limited is more than that.The vpn client all use pptp and not the ipsec.IOS is rsp-ik9sv-mz.123-8.T11.bin.I want to k...

i have a 2821 router with 2 giga and 16 fastethernet ports that have been configure with no switchpotrt command. am running eigrp. however the switch network module keeps hangs very often. help

HI all,I have a fiber link between two 7606 routers, the thing is the OSPF isn´t able to change to the FULL state, it stops in the EXSTART. Here is the two interfaces configuration:interface GE-WAN1/1 mtu 1508 ip address 10.9.129.1 255.255.255.252 ip...

CAn you please tell me the usage of the following commands. And also suggest if removing this might hamper the router functionality in any way, as my ROuter has been hanging frequently.ip flow-export source Ethernet0/0 ip flow-export version 5 ip flo...

I have a GSR running redundant GRP-B= with 256DRAM. We need to upgrade the GRPs to 512MB memory. My plan is to remove the standby GRP first then install the additional memory cards then insert it back. At this point, can I just remove the active GRP ...

Hi, can I know what IOS command can be used to check the leased-line speed?