Routing

Hi, Is it possible to receive an e-mail as soon as the serial interface goes down?How can I do that?I was thinking about installing a syslog server and configuring a snmp server in the router but I think I need something more to make it works.Thanks

Hi,Can anyone please help me out!!! i have got the 2 MB LL which is normally congested i wana see what sort of the traffic is making my link congested.I donot have the access to other router and i want to keep a check on unwanted traffic on my seria...

Hi all, May I know whether Cisco IOS router can support destination NAT or not from outside to inside? If so, is there any example to show the configuration? Thanks a lot in advance. Regards, mak

I have a multi-tenant building that has 30 customers and I am going to provide internet access to them using a primary link (30meg) and a secondary T-1 for failover. I want to give everyone a public static IP address that is on my primary gateway su...

I am having problems between 2 sites. The connection is intermittent. My main side is a 7513 with a ds3 card. The interface for the site that is the problem (s1/0/0/24:1) is throwing up input, crc and frame errors. The remote site is a 2500 with an e...

I just configured 2 of these routers and I need to verify the "no shutdown" interface is set correctly - how do I do this? Thanks in advance.

Does anyone know if an 1800 router exists without wireless. Back in January we bought one (not CBAC firewall) and no wireless. I look on cisco site now and ask our suppliers and we can only get this with wireless. I have a p/n 341-0135-02 but no o...

Hello,I have a client that currently is running a 1700 series router. In turn this router seems to be having problems so the client decided to purchase a new router (1841).After getting the config from the older router I have placed this into the new...

Router 1:interface Loopback1 ip address 192.168.1.1 255.255.255.0!interface FastEthernet0/0 ip address 154.x.x.10 255.255.0.0 duplex auto speed auto no mop enabled!interface FastEthernet0/1 no ip address shutdown duplex auto speed auto!interface Seri...

I have an established site to site IPSEC tunnel from location A to B. I need to establish a remote site C from site A simultaneously. The equipment is two 2811 routers. Can I create two tunnels on one serial interface? I have created one crypto map a...

Dear All,We have a connection from headquarter to remote office using 3 E1 lines....and using EIGRP as our routing protocol..and of course let load balancing.The problem is when I show ip routing.. every ip destination traffic always goes through the...

Hi,I am coming across a typical problem regarding Frame Relay configuration.One of my client is having a sub site connecting to main site router via a Frame Relay provider network.Frame Relay is configured as point to point sub interface end to end.F...