Routing

What does bantam jack do on NM-2CE1T1-PRI card ?

Hi..Can an AS5400 with 16E1 be also used as a conventional router along with routine RAS..??

I Have a Cat6k (SUP1A/MSFC2) running IOS 12.1(20)E doing eBGP with several ISPs. BGP sessions have been up and running for quite some time just fine. Recently, I made a change to the neighbor inbound route-maps and removed the "set weight xxx" statem...

we have hub and spoke topology. I have setup vlan interfaces for each site with trunking on the interface link between HQ and provider. I am experiencing some odd layer 2 behavior. Is there a more robust and stable method - configuration setup using ...

Hi, I'm currently a frame-relay customer that is considering going MPLS. With frame-relay I am currently running DMVPN with 3DES and GRE. Is there anyone here an enterprise MPLS running a similar configuration? I can peer through an MPLS cloud?

please advise...i am to buy a cisco router that would enable me to share a 2 leased lines (wic-1T modules) connected to 2 different service providers. is there a solution to do that without additional setup from the provider's side? maybe CEF??? what...

I am getting ready to add a connection to a second ISP for redundancy and additional bandwidth. I'm still in the planning stage and am looking for some guidance and maybe configuration examples. Also any pitfalls to look out for and best practices....

I am attempting to connect my Cisco 515E to a site to site VPN. The IP on the other side has the same IP # as my PIX. Will this be a problem?

We have recently upgraded framerelay link speed to 2MB before it was 512KB. But we are unable get the 2MB link speed. Our service provider is claiming that the link speed is 2MB. He tested in front of us connected speed tester with modem. Our serial ...

Hi All,On a GRE tunnel with a full T1, how much actual bandwidth can be used for tunnel data? It looks like the bandwidth is set for 9kb by default. Does this have any influence on actual bandwidth? Are there any settings to manipulate how much bandw...

Anyone know what this means ?Am trying to do rfc1483 bridging over AAL5/snap encapsulated PVC but keep getting encapsulation failed.rfc1483 routing works but wanted to do IRB to accomondate a small subnet.

hi,i have 2 iplc links and 1 mpls link .all these cater to same location.i plan to have a load balanced and fail over scenario.can i assume per packet load sharing in this scenario?how??is it possible i can run EIGRP on all the links and let it decid...

I have a T3+ PA 1 port adapter in a 7304 and NM1T3/E3 in a cisco 3745.If the interface goes down by an alarm or cable disconnection, it never recovers itself. Also reboot does not help.Only work-around is to remove "card type t3" , reboot router and ...

i have a customer connected to my PE router .he is connected through ebgp.he needs to have his routing table size reduced.could anyone let me know how to achieve this ..i guess static routes will will be one solution...