Routing

I create IPSce from my windows xp to cisco 831 router and it works. Now, I try to create a site to site vpn using Linksys BEFSX41 router and Cisco 831 router, but can't make it work. Can I creat a site to site vpn between these two routers? If yes, c...

Can anyone tell me if it is possible to bond a full T1 with a frac-T (12-Channels) using MPPP in a Cisco 1720 Router? In essence providing 2312K data BW. The other 12 channels would be utilized for voice services and split off prior to hitting the ...

I can't seem to find how many ds3s the 7204 supports?They have several different Network Processing Engines.With NPE225 NPE400 NPE-G1It is possible we will move our vpn connection to the 7204. That would enable us to do virtual firewalls wit...

Dear sir,I am Class A service provider.I am running BGP with same service provider on 2 of my branches.branch1 : ISP 1branch2 : ISP 1Suppose ISP 1 international bandwidth is down for branch1 only. But branch2 is not affected by it.So can you guide me...

cisco site says nm2ce1b is supported on cisco2610.but when i insert the card into 2610 , the router is hanging.could anyone tell me the minimum Flash and DRAM requirement for nm-2ce1b to be supported.i have 8Mb flash and 32MB ram.Regards

Dear all,I find that VWIC option only support E1, if I want to support T1 with G.703, any modules I can use?Thanksmak

It appears from the following text in a Cisco manual "Routes configured with the connected keyword affected by this redistribute command are the routes not specified by the network router configuration command." That the REDISTRIBUTE CONNECTED statem...

Hi allWe have created a VPN tunnel between two 1841 routers( lets say 1(GKN_faridabad) and 2(gkn_dharuherA). One of the routers is globally connected to singapore via IPLC. Now the mail SERVER is located in singapore and both the ends of VPN are able...

HI all,Today I faced a problem with 1721 series router which is worth sharing. I could ping the router but could not telnet into it. There was no access list on the line vty 0 4,I gained access to the router only when I asked the tech to put the foll...

Can you please let me know if I can configure HSRP on a single router with two ethernet interfaces. Thanks

Good dayOn our system, we have a CMTS (UBR 7246) and cable modem.Behind the cable modem we have two equipement connect by a switch (Quintum for ip telephony and a router).Certain time the mac adress adress of quintum does'nt appear on CMTS arp table...

Hello,I have a problem. When I remove the ip address of this sub-interface fa0/0.32 all of my eigrp neighbors lost except this 192.168.11.214 neighbor. Why could it be ?The configs:---------------------------interface FastEthernet0/0.32 encapsulation...

I have routers and ap´s. All interfaces are configured with fifo.Should I use fair queue instead? Is it a better choice? Even with the 350 Ap´s?thanks