What method is used to implement Traffic shaping in outbound direction? Please explain a little bit. Thanks
Forum Posts
What is hardware and software base queuing? Please need your support. Thanks
What are VRRP messages and their types? We need your kind support on it. Thanks
How OSPF perform load sharing. Does load sharing and load balancing are same things?
When we configure summary route in OSPF, a route to null 0 will be installed into OSPF routing table. What is the reason of it. Kindly need your support. Thanks
Hi, I'm new at networking, currently i have ISR4331 working as Router and i have Juniper EX2300 working as L3 Switch that will be my local gateway of my each VLANS i have.Here's the look of my current topology I have problem where from all of my inte...
Hi Team, I am trying to configure EVPN in Cisco ASR-920. It works good as long as both the devices are in same AS but doesn't work across different AS (e-BGP). Does ASR-920 support inter AS EVPN? Please advise. Thanks ... Rajan
Resolved! NAT before IPSEC
I'm struggling to determine how to configure NAT on my C8200 and CSR1000v to support the following scenario. I have hosts in 192.168.1.0/24 (identified as being behind R1) that need to establish a connection to hosts in 192.168.3.0/24 (identified as...
Every Cisco Switch Serie has Switches which end with "E" & "A". For instance "C9200L-24T-4X-A" & "C9200L-24T-4X-E".What does those A & E mean ? I don't notice any deep differences between them. Thx in advance
Hi all Does anyone know how to go about getting BFD offloaded in hardware on the Cat9500 platform?More specifically we're talking about the C9500-24Q device. We're currently using BFD, but everything is handled in software as per the output of the "s...
Please send me other reference link documentation on cisco apart from this "https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/mp_l2_vpns/configuration/xe-16-9/mp-l2-vpns-xe-16-9-book/evpn-multihoming.html" because this documentation not explain for c...
How do I replace the sensor that is broken?Is it a module or is the entire switch? fault code f0449topology/pod-1/node-111/sys/ch/subslot-1/sup/sensor-5 Temperature: -----------------------------------------------------------------------------------...
Created a link aggregation on three switches but when i connected my computer to the switches to talk to one another it isnt working. where did i go wrong? below is my cisco packet tracer information.
what is the difference between RTU and evaluation license?
Hi All I am getting the message "Authentication expired" on my Cisco router whenever I type in any command. Now I am guessing this is related in some way to the login credentials I am using. But I note that the login credentials I used to log onto t...
