Hello All, We run the BGP over the IP Sec Tunnel, so we need to create the PAT to translate the incoming IPs from FW 1 to the loopback interface to communicate with the other subnet in the firewall 2 via the loopback interface. so i need to know h...
Is there an API call that can retrieve the CSV data for the device specific variable/values? The equivalent of going to vmanage > Configure > Devices > {device} > Change Device Values > Download CSVWe're migrating several dozen sites in the near futu...
I have a site comprised of three garages, each equipped with a Cisco Meraki GX-50 Plus firewall. The site has a premise based server in one garage and we are using the site to site capabilities withing the Meraki’s for the two “satelite” garages to c...
Listen here: S11|E9 Simplified Management and Security with SD-Routing Many Cisco enterprise customers have decades of Catalyst routing and security capabilities functioning at branch locations. As distributed sites grow in complexity, networking tea...
hello guys i was able to setup my vmanage , vsmart and vbond succesfully , vbond is CA server.however i am now trying to onboard the Vedge but it first needs to be added to "wan edge list" on Vmanage. my vmanage does not have access to internet but ...
Hello, I have a problem when I push Template from vManage to cEdge Router. I am getting the following errors [11-Jul-2024 18:10:59 EET] Configuring device with feature template: Taj-cEdge02_Template [11-Jul-2024 18:11:00 EET] Checking and creating d...
Hi guys,Is it possible to use Portchannel links instead of individual links for TLOC extensions on two Cisco 8300s?
Hi all, Trying to influence selection of DIA path from a c8300 router based on data path policy, I'm not convinced that it is working. I was reading this fairly old (2020) guide: https://www.cisco.com/c/dam/en/us/td/docs/solutions/CVD/SDWAN/sdwan-dia...
Hi EveryoneWe are running into continuous issues where the Switch Management at remote sites pretty slow over SSH, the Access Points lose association with the Controller at the Hub.Currently, we are operating a 140Mbps link at the Spoke Site. The QoS...
I know other vendors have a solution for endpoints(end users) to connect with SDwan. Does Cisco-Viptela? Sounds like a no brainer that end users would be the last piece to connect into a fully connect tunneled environment instead of having a separate...
I have a PNETLab on a ESXi Server, and I started a SD-WAN test on my PNETLab. And I found I can't connect my vManage node to external network. As you know connection to external network is needed to to access vManage GUI environment, but there are on...
Hi Community,I have an SDWAN solution in the Cisco cloud, 2 vBond, 2 vSamrt and 1 vManage, and it is observed that their certificates are about to expire:Furthermore, it is observed in vManage that the authorization of the controller certificates is ...
I'm working on this architecture . So I wanted to configure mpls in it . I typed these commands : PE11 : int loopback 0ip address 1.1.1.1 255.255.255.255no sh exit ip cefmpls ipmpls label protocol ldpmpls ldp router-id loopback 0 forceint g1/0ip ad...
In my environment, Cisco SD-WAN Web server certficate is expiring. What is the impact if is expires ? What will happen if I dont renew it.
Hello, Greetings! Requesting for help on the below vManage high availability (Disaster Recovery) configuration. We want to deploy vManage controllers in active/standby (Disaster Recovery) configuration. One vManage will be in primary DC and second vM...
