Server Networking

Dear all,I have a query on link load balancing. My scenario goes like this. The customer has taken web hosting services from two data centers. When an user who is accessing the servcies available in primary data center gets disconnected due to say li...

I have a simple DLSw config that doesn't seem to be working. The peers are up, but when the "debug source bridge" command is issued the following appears on the screen...Error only happens on R2Oct 18 09:58:22 EDT: SRB0: explorer enqueued (srn 116 b...

Hello,we are planning to migrate FEP to a cisco router. This FEP is used to terminate x.25 connections. The alternative if QLLC is used is to use a DLSW enabled router. However if QLLC is not used then I will need additional SW on the Mainframe so as...

I have a couple of questions regarding the following equipment. Supervisor engine 2 part # WS-X6K-SUP2-2GE. The switch load meter does not appear to work. Is there some configuration that needs to added/changed to make it work on the active engine? I...

We're trying to reverse telnet from an AS2511 async ports to a Larscom Mega-T inverse mux DB9M SUP1 port. The AS2511 RJ45 uses pin 3/4 TXD&RXD and Larscom uses pin 2/3 TX/RX. All control LED up but we can't reverse telnet. Has anyone implemented suc...

what of the following descriptions best descripe the global command??a- a command that avilaleble in every IOS relasesb- a command that can be entered witin any configuration mode.c- a command that configured once which affects the reset of the route...

How to make APPN of a MF for the other using interface OSA? I have in a side to router 2210 IBM and in the other a Cisco 7200.Thanks

Hineed all of your suggestmy cx use 3270 Emu program which enable keep alive 30 second in it's default configwhen client idle 30 second,it auto triger keepalive to TN3270 server(7507)But 7507 send back TN_DEV_IN use(TN device in use)to client,and cli...

Exists any way to configure multiple local peers in a router ? via NAT or other solution?

what does global command mean?

Hi!I have 1 router (CISCO 2501) with 73 connections configured on it. They are 73 "X25 MAP QLLC...".Each connection has a VMAC address to configure in the server (Microsoft SNA Server).Example: X25 MAP QLLC 4000.3500.0001 999910004107101X25 MAP QLLC ...

I have corrupt entries in the ethernet redundancy transparent cache. These are causing problems establishing new sessions.Can I clear the entries individually and how long does the cache take to time out?