Server Networking

Is there any change for support for vSphere's LACP load distribution setting for a VMware vDS port group with the DvUplinks of the vDS port group configured for at least one uplink for Fabric A and Fabric B? I do not think there has been but i have a...

Hi All, I have a Customer who has purchased a C 240 -M4 , it has Cisco 12G SAS Raid Controller installed and to boost performance , he bought a UCSC-MRAID12G-4GB addon module , I was looking  for the installation , apparentl Cisco did not send any in...

Hello everyone,I was hoping someone had a setup guide for LDAPS on UCSM for accessing AD.  Thank you

We are having an issue with our IPs of our Direct KVM being flagged with an Apache web server vulnerabilities. We do not even use the IP KVM and wanted to know if there is a way to disable the IP KVM all together. Is this possible? If so how can i do...

Hi guys,I hope you can help me with the following, i've tried search with no luck so far. The Scenario:We (my Company) is managing a DataCentre-environment, with UCS, VMWare, Nexus 1000v etc etcThe VCenter-server has an IP-address in one network that...

Hi,   I'm planning to upgrade Nexus 5548UP (no L3 services) from 5.2(1)N1(6)  to 7.0(5)N1(1). Is this upgrade path vaild? or is there any intermediate version; also advise if ISSU is possible. Regards, Navin RK

Hi all,Need some suggestion. Has an UCS environment, two FIs one Blade Chassis 6 Blade Servers, 2 Servers with 256Gig Mem and 4 with 128Gig Mem.2 Servers with 128 and two servers with 256 Gig working correctly from the beginning. Then we tried to add...

All,While researching UCSM server pool policies it was noted that to build one you usually construct them via:1. Define a Pool2. Define a Server Pool Policy Qualification3. Tie the two above together with a Server Pool PolicyThe documentation states ...

Dears ,any one can help me in connecting the followingBNT 10 fabric switch with Nexus 7000 using port channelhow to configure it as port channel in BNTdesign as attached 

Hi all,I'm trying to connect in FCoE mode a UCS 220 M4 + VIC 1225 card to a NEXUS 5596.1 - I have enabled the FCoE feature => feature fcoe2 - I have configured vHBA card with default vlan 900 on UCS3 - I have created vlan 900 + vsan 900 on the NEXUS4...

Good morning, I am trying to find why our N2K are sending pause frame to the host when to uplink is not congested. fex is a 2232N5K running 7.1 sample interface counters : Ethernet109/1/2 is up  Hardware: 1000/10000 Ethernet, address: d4d7.481c.4143 ...