Switches - Small Business

Hi all, I have a cisco sg300-10 where one of my ports are configured as below: !interface gigabitethernet7 shutdown description "TV-dekoder stue" no spanning-tree portfast switchport mode access macro description "cisco-desktop   | no_desktop"! No...

Admittedly, I am not very knowledgeable about spanning tree... and I'm being unable to sort out a basic scenario because of it, and I'm unsure whether it is a behavior related to the small business switches and/or 300 series only.   Please take a loo...

I have a SG200 50 port switch. I have two interfaces that have very frequent Packets with Errors. They are both connected to servers. I frequently lose connectivity between those two servers. I'm looking for information on what could be causing the e...

Hi there.I'm wondering if anyone knows to set up the switch so that when I'm connecting via SSH, the switch doesn't prompt for a username if I supply one in the initial connect request? For example, we usually connect by typing something like the fol...

Hi all, I have a cisco sg300-10 where one of my port are configured as below: !interface gigabitethernet7 shutdown description "TV-dekoder stue" no spanning-tree portfast switchport mode access macro description "cisco-desktop   | no_desktop"! No ...

I am having a problem with a SG300-10MP that is a couple years old. I just reached a point that I really need to use ports 9 and 10 (the combo ports) and I cannot seem to get them to go active. I will admit that I am not experienced with Cisco and ha...

Hi, I have a cisco SG300-10PP (PoE) switch to which i have 7 Cisco AIR-CAP2702I-D-K9 wireless access points connected. one of the ports of the remaninig ports is connected to a core switch. The APs are being managed by Cisco WLC 2504.  Now this 10 ...

I'm having a hard time setting up a trunk between a Cisco 3750 running lanbase 12.2(55)SE3 firmware and a Cisco Small Business SG300-10 running v 1.3.5.58 firmware. There are two vlans on both switches, vlan 1 and vlan 200. On the 3750, I already hav...

HiNow when going into webview in this switch, under statistics-> Port Utlization you see a % for every port ,now that is the value i want but i cannot find the MIB/OID to use to get that value. I believe there is nonethat port utlization is a calcula...

Not sure what's causing it but every once and awhile all the ports go down and its like the switch reboots. In the logs I can see is the switch saying all the vlan's and port group are down and then they come back online. Anyone know what causes this...

Hello everyone, I need somehow to get notifications when MAC address is added/removed and on which port. Something in IOS language: interface FastEthernet0/24snmp trap mac-notification change added!mac address-table notificationsnmp-server enable tr...

Hello! I have SG-200-50 (FW 1.3.7.18 Boot 1.1.06) and SG-200-18 (FW 1.3.5.58 Boot 1.3.5.06). Have 4 Mini-Gbic ports in inventory: 2 Linksys MGBSX1 and 2 Cisco GLC-SX-MMD When I try to connect switches between 2 Linksys MGBSX1 in ports (GE49-GE17) I g...

I have three cisco Rv082 switches connecting to load balancing draytek vigor 300b  Problem is I have advanced routing (static routing) configured as, ip address range, gateway of Wan port of the destination cisco switch. I have not added any static ...