Switches - Small Business

Hi all,I got a switch crash several hours ago, switch type WS-C2960G-48TC-L, running IOS "flash:c2960-lanbase-mz.122-35.SE5/c2960-lanbase-mz.122-35.SE5.bin". Crashing might occur the first time as I know, and after auto rebooting it works well till n...

1、 CISCO SG500设备采集CPU使用率的mib值是多少？2、用什么方法查找cisco设备的对应性能如:CPU利用率、内存使用率的mib值？3、有哪些比较实用的mib软件

Good morning,I'm observing what appears to be a bug in the smartport feature on our SG300 switches. We use this for our Auto Voice VLAN. We are using our own user defined macro's in place of the ip_phone and ip_phone_desktop as we use native vlans di...

I followed all the required steps :. Creating a Remote Engine ID : remote IP address / remote host Engine ID. Creating a SNMPv3 group, like when using SNMPv3 traps. Creating a SNMPv3 user and make it use our remote Engine ID. Finally setting the SNMP...

Hope that somebody can help me with the setup in the screenshot. Planning to use Auto-Voice VLAN and Smartports to configure VOIPLLDP-MED will be enabled on the switch to detect the IP phones so they will be moved to the Voice VLAN (If not the first ...

Can you please help on how to setup QoS parameters for IP phone end points that are having issues dropping packets, etc  when calling the public network.

Hi,I have been tasked with setting up a small wireless deployment for a single client site. What I have been looking at for choice of equipment is the Cisco SF302-08MPP Layer 3 switch, a Cisco 2504 Wireless LAN controller, and the Cisco 1600 Lightwei...

I'm using SG200-26.  I updated the admin password, then I set a static IP.  All good.  *BUT* everytime the device is restarted/power down/etc, it LOSES all the setup and goes back to factory default. Not a clue WHY.  Never seen anything like it.  Can...

Hello together,We need on a SG300 or SG500 the functionality of IEEE 1588 for synchronization of a PBX-Base-Station. Which Switches do that? Kind regardsMonika Pachera

Hi there, I've configured a network with 5 (and more Servers later). Each Server has 4 1GB Network interfaces, configured to bond.I'm using balanced-XOR mode so this doesn't need special switch configuration.Now I want to add some fault tolerance, th...

Hi please excuse my ignorance and lack of knowledge in this field as I am a complete newbie when it comes to Cisco switches and VLANS etc. but trying to learn.I have a Cisco 300-24P and need to create two separate networks (private and public) ports ...

Is there a way to show interface overruns? I wish they'd use the same syntax as on their enterprise switches.

Hi,reading this page: http://www.cisco.com/c/en/us/products/collateral/switches/small-business-smart-switches/data_sheet_c78-610061.html ; I noticed that there is written that the MGBSX1 maximum distance on SG300 or SF300 Series is 300 meters.On the ...