Switches - Small Business

Dear Support, I have a Cisco SG300 and Cisco 3560 switches.3560 is my Core Switch and SG300 is access switch.From 3560 VLAN information is not passed to SG300. 3560 Configuration:interface GigabitEthernet0/23switchport trunk encapsulation dot1qswitch...

When I try to connect to my SLM2048 I receive the following message: "your browser does not seem to support xsltprocessor"How can I resolve this ? I'm using IE 11 and Chrome 40.0.2214.93 m 

Dear Support, I have a Cisco SG300 and Cisco 3560 switches.3560 is my Core Switch and SG300 is access switch.On 3560 my all VLAN are configured and my PC which is connected to SG300 is not able to ping the gateway.From 3560 VLAN information is not pa...

Hi there, i hope you can help me i just created a vlan on a L3 Cisco SG300-28MP and works great but only if my RV042G firewall is off what can i do ? thanks in advance !!!

Here is the Scenario: - Cable Modem connected to ISP with 100Mbit/s Speed.- Cisco Router RV325 connected to Cable Modem on WAN1 port. Router acts as DHCP Server with 5 VLANs.- SG500-52 Switch (In router Mode) connected via trunk port to LAN2 port of ...

So we are putting a new cisco sf500 48 switch and I need to create a trunk on port 48 to allow traffic from our Layer 3 switch. When I trunk port number 48 and tag VLAN 100 and 200 the workstations are unable to communicate with devices on VLAN 200. ...

I would like to have some help putting together a script for rebooting our 300 series POE switches. I have about 150 at this stage to administer and it would make it much easier not to have to remotely reboot them. The IP settings will be the same fo...

I would like to have some help putting together a script for rebooting our 300 series POE switches. I have about 150 at this stage to administer and it would make it much easier not to have to remotely reboot them. The IP settings will be the same fo...

We installed SG300-52 switch on the network. When 2 servers attached to that switch and we try to ping one server from another we get latency that varries from 6ms to 52ms instead of <1ms. Swith is running in L2 mode with latest firmware (1.3.0.62) a...

I've been using the CNA for our 3560X type switches and really like it.I saw the lastest version would support the Sx300 switches. I tried it on some of our SF302-08P switches and it worked great!But then I tried it on a new one, with newer firmware ...

Hello. I am having two problems with internal web servers and VLANs. Here is a description of the existing infrastructure: Business cable modem with a block of static IPs. These IPs are for example only and are not my current set, just an ourdated se...

I recently enabled jumbo frames on my SG200 to experiment a bit and see how they work.  Before I started I made sure I was at the latest firmware which I believe is 1.4.0.88 at the moment.  My environment consists of an SG200 28 port switch.  A Dell ...