Switches - Small Business

Hello,We recently installed a 200 Smart Switch.  I changed the IP address to 192.168.210.2 and everything was working fine.  Everything is still working fine except that I now can not access the switch using the IP address.  I can not ping the addres...

We are trying to implement a SLM2024 into our environment to be used on a  lab bench. I am trying to get trunked traffic from a Catalyst 4948 to  this switch. The Cisco documentation on how to do this on the 2024 is  not very good. Does nyon know the...

Hi, anyone knows if there is a way to configure a secondary ip address (over the same address range) in a vlan interface on the SGE2000?For example, I want Interface Vlan 10 on mw switch has 172.16.10.1/24 and 172.16.10.2/24. Is that possible? If I t...

Sorry for my poor english. My SG300-52 is struck in reboot loop after i set tcp congestion avoidance in webui.********************************************Boot1 Checksum Test...............................PASSBoot2 Checksum Test..........................

I am having an issue with setting a port in access mode and assigning it to a vlan.I have a 300 series switch in layer 3 mode that is handling intervlan routing.I also have a cisco 2651xm WAN router that handles the routing for the voice vlan.Everyth...

How many VLANs does the ESW 500 switch support?

I have just downloaded new software for sge2010p. I had tried to made an upgrade on some switches, but switches still boot with the old software.I have installed software 3.0.0.18 and boot  2.0.0.03. I have downloaded software 3.0.1 from cisco, put i...

Hi there,my problem is:the switch sge2000-g5 a small busines switch, has a redundant power supply port built in the switch. It is a port that handles a 12v power supply.My problem is to find the exact device to supply the power to this port so I can ...

Hi, Im trying to get my head around my new cisco SG 300 switch.  Im not very experienced but I have used the Linksys SRW range before and configured it using teraterm and method described in the link below:http://homecommunity.cisco.com/t5/Switches/S...

I have an SG 100D-08 and an SG 100-16 for use in a Development lab -- specifically working with M$ SCCM 2007 and Windows Deployment Services for WIM image (Windows 7) deployment.The 100D-08 was plug and go and works fine for both unicast and multicas...